CFD Modeling of Macro-segregation and Shrinkage During Solidification of Superalloy Castings

نویسندگان

چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Near-congruent solidification of castings

Chaput Kevin J. Ph.D., Purdue University, May 2015. Near-Congruent Solidification of Castings. Major Professor: Kevin Trumble. A study on the microstructure development of as-cast Cu-Mn alloys based around the congruent minimum at 34.6 wt % Mn and 873 oC was performed. Initially, this was to evaluate the alloy as an alternative to wide freezing range Pb and Sn bronzes that are plagued with poro...

متن کامل

Numerical and Experimental Investigation of Solidification Shrinkage

The solidification heat transfer, melt convection and volume shrinkage in the casting of an energetic material are analyzed through numerical modeling and experimental investigation. The shrinkage resulting from phase change is considered through the volume of fluid method. The model is validated against an analytical solution and then applied to study the volume contraction during the casting ...

متن کامل

Channel segregation during columnar solidification : influence of inertia

The numerical prediction of channel segregations during two-dimensional columnar solidification of Sn-Pb alloy is analyzed when inertia is considered in the dendritic mushy zone. This contribution is included in the momentum transport equation through the quadratic Forchheimer correction term. A significant influence of the Forchheimer term in the vicinity of the liquidus region is found. The n...

متن کامل

simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: ISIJ International

سال: 2010

ISSN: 0915-1559,1347-5460

DOI: 10.2355/isijinternational.50.1829