CFD analysis of steam superheater, transient state
نویسندگان
چکیده
منابع مشابه
Computer modeling of a convective steam superheater
Superheater is for generating superheated steam from the saturated steam from the evaporator outlet. In the case of pulverized coal fired boiler, a relatively small amount of ash causes problems with ash fouling on the heating surfaces, including the superheaters. In the convection pass of the boiler, the flue gas temperature is lower and ash deposits can be loose or sintered. Ash fouling not o...
متن کاملCoupled Cfd and Thermal Steady State Analysis of Steam Turbine Secondary Flow Path
The main purpose of this work is to conduct coupled CFD analysis of the steam flow in the secondary part of turbine and study thermal rotor/stator steady state. We consider a 11 stage high-pressure cylinder of a power steam turbine with extended terminal labyrinths. Domain of interest is only the secondary flow path of the cylinder, therefore the shroud and blades are beyond the scope of this w...
متن کاملCalibration of CFD Model for Mist/Steam Impinging Jets Cooling
In the heavy-frame advanced turbine systems, steam is used as a coolant for turbine blade cooling. The concept of injecting mist into the impinging jets of steam was experimentally proved as an effective way of significantly enhancing the cooling effectiveness in the laboratory under low pressure and temperature conditions. However, whether mist/steam cooling is applicable under actual gas turb...
متن کاملCFD-simulation of membrane reactor for methane steam reforming
A membrane reactor is a reaction system that provides higher productivity and lower separation cost in chemical reaction processes. In this paper, packed bed catalytic membrane reactor with palladium membrane for methane steam reforming was analyzed both experimentally and numerically. The numerical model consists of a full set of partial differential equations derived from conservation of mass...
متن کاملCFD modeling and control of a steam methane reforming reactor
This work initially focuses on developing a computational fluid dynamics (CFD) model of an industrialscale steam methane reforming reactor (reforming tube) used to produce hydrogen. Subsequently, we design and evaluate three different feedback control schemes to drive the area-weighted average hydrogen mole fraction measured at the reforming tube outlet ( x̄H outlet 2 ) to a desired set-point va...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: E3S Web of Conferences
سال: 2019
ISSN: 2267-1242
DOI: 10.1051/e3sconf/201912804009