CFD analysis of fluid flow in an axial multi-stage partial-admission ORC turbine

experimental and numerical study of partial admission effect on flow distribution in supersonic turbine axial-gap

in high-pressure axial turbines, when the fluid mass flow is low, the supersonic blades are being used to obtain a high specific work output. to prevent losses due to low blade aspect ratio, the turbine is used in partial admission conditions. the turbine stator is a group of convergence-divergence nozzles that provides the supersonic flow. the design of these nozzles is important, because ther...

CFD-Calculation of Fluid Flow in a

An accurate description of the fluid flow and heat transfer within a Pressurized Water Reactor (PWR), for the safety analysis and reactor performance is always desirable. In this paper a mathematical model of the fundamental physical phenomena which are associated to a typical PWR is presented. The mathematical model governs the fluid dynamics in the reactor. Using commercial software CFX, a co...

A Numerical Investigation on the Unstable Flow in a Single Stage of an Axial Compressor

An unsteady two-dimensional finite-volume solver was developed based on Van Leer’s flux splitting algorithm in conjunction with “Monotonic Upstream Scheme for Conservation Laws (MUSCL)” limiters to improve the order of accuracy and the two-layer Baldwin-Lomax turbulence model was also implemented. Two test cases were prepared to validate the solver. The computed results were compared with the e...

Development of a Multi-Stage Axial Flow Cyclone

Design and CFD analysis of an odontoiatric turbine

Scope of the analysis presented in this work was the improvement in the design of a microturbine for dental applications. The initial choice was an impulse turbine operating in subsonic regime with air as working fluid and a behavior similar to Turgo turbines. The work was performed in several stages: the first step focused on documentation of these turbines, followed by a dimensional study bas...