Ceramic fibre reinforced refractory castables for very high temperature superplastic forming
نویسندگان
چکیده
منابع مشابه
Cavitation During Superplastic Forming
Cavitation is the opening of pores during superplastic forming, typically at grain boundary triple points or on second phase grain boundary particles during slip of grain boundaries. Theories for the initiation of cavitation are reviewed. It seems that cavitation is unlikely to occur by processes intrinsic to metals such as dislocation mechanisms or point defect condensation. It is proposed tha...
متن کاملWear of ceramic-on-carbon fibre reinforced PEEK hip replacements
Total hip replacement has been a successful surgical intervention for many years. However, concerns regarding UHMWPE wear particle induced osteolysis [1], have led to alternative bearing materials to be sought. Carbon-fibre reinforced poly-ether-ether-ketone (CFR-PEEK) is a fibre-reinforced polymer which has shown reduced wear in hip and knee configurations compared with conventional polyethyle...
متن کاملFrictional heating in a unidirectional fibre-reinforced ceramic composite
Holmes and Shuler [1] recently found that significant internal heating occurs during the cyclic loading of fibre-reinforced ceramics. In their investigation, conducted with cross-ply carbon fibre/SiC matrix composites (hereafter referred to as Cf/SiC), it was observed that the extent of internal heating was strongly influenced by the peak fatigue stress and loading frequency. For example, durin...
متن کاملHIGH TEMPERATURE ELASTIC PROPERTIES OF REFRACTORY MATERIALS
Abstract: A pulse-echo technique, based on ultrasonic "long-bar" mode (LBM) velocity measurements, working up to 1700°C is described. Magnetostrictive transducers and ultrasonic lines used in a 40-85 kHz frequency range are detailed. The conditions of choice of fundamental parameters (frequency, line geometry, sample size) are discussed in relation with the nature and the microstructure of ...
متن کاملOptimization of Superplastic Forming Technology
The objective of this paper is a superplastic forming (SPF) technologies design and optimization. The conditions of superplasticity are very sensitive to strain rates and temperature characteristic of deformation process. The presented work gives an approach to design the SPF technologies that satisfies such conditions.A possibility to decrease the temperature of the industrial forming of the T...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materialwissenschaft und Werkstofftechnik
سال: 2012
ISSN: 0933-5137
DOI: 10.1002/mawe.201200032