Centrifugal Lubrication of Spur Gears. 2nd Report, Influence of Cooling Hole on Tooth Fillet Stress.

Influence of dynamic behaviour on elastohydrodynamic lubrication of spur gears

In this study, the elastohydrodynamic lubrication (EHL) behaviour of high-speed spur gear contacts is investigated under dynamic conditions. A non-linear time-varying vibratory model of spur gear pairs is introduced to predict the instantaneous tooth forces under dynamic conditions within both the linear and non-linear operating regimes. In this model, the periodically time-varying gear mesh st...

A Finite Element Stress Analysis of Spur Gears including Fillet Radii and Rim Thickness Effects

Efficiency and temperature of spur gears using spray lubrication compared to dip lubrication

Increased machine efficiency is a requirement in today’s world and geared transmissions are no exception. A back-toback gear test rig was used to compare dip lubrication with spray lubrication regarding gearbox efficiency, mesh efficiency, gear temperature and surface roughness. Gears lubricated at the inlet of the mesh show a lower measured temperature when compared to spray lubrication at the...

Cooling and Lubrication of High-speed Helical Gears

Centrifugal compressor and turbine manufacturers are building machines that operate at increasingly higher speeds to reduce the size and cost of their equipment. Helical gears are commonly used to step down the speed of these machines to match nominal motor and generator speeds. The demand for higher compressor and turbine speeds has resulted in an increase in the maximum pitch line velocities ...

Influence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears

Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...