Cavitation Erosion of SiC-Whisker-Reinforced Aluminum Composite.
نویسندگان
چکیده
منابع مشابه
Fatigue crack growth resistance in SiC particulate and whisker reinforced P/M 2124 aluminum matrix composites
Fatigue crack growth is examined in P/M 2124 aluminum alloys reinforced with SiC particles (SiCp) and whiskers (SiCw) over a wide spectrum of growth rates from 10 to 10 m per cycle. Effects of aging treatment, orientation of crack growth direction with respect to the rolling direction, mean stress (or stress ratio), and reinforcement volume percent on the fatigue crack growth threshold are inve...
متن کاملMechanical properties of hydroxyapatite whisker reinforced polyetherketoneketone composite scaffolds.
The apparent mechanical properties of hydroxyapatite (HA) whisker reinforced polyetherketoneketone (PEKK) scaffolds were evaluated in unconfined, uniaxial compression to investigate the effects of the porosity (75%, 82.5% and 90%), HA content (0, 20 and 40 vol%) and mold temperature (350, 365 and 375 ( composite function)C). Increased porosity resulted in a non-linear decrease in the elastic mo...
متن کاملSolid particle erosion of Bagasse fiber reinforced epoxy composite
Experiments were carried out to study the effects of impingement angle and particle velocity on the solid particle erosion behavior of Bagasse Fiber Reinforced Polymer Composites (BFRPCs). The erosive wear is evaluated at different impingement angles from 30° to 90° at four different velocities of 48, 70, 82 and 109 m/s. The erodent used is silica sand with the size range 150 – 250 m of irregul...
متن کاملNUCLEATION PHENOMENON IN SiC PARTICULATE REINFORCED MAGNESIUM COMPOSITE
Metal matrix composite (MMC) technology can improve the service performance of matrix metals and alloys. Most magnesium alloy based MMCs are produced via a casting process, therefore the casting microstructures are of vital importance to their performance in service. The formation of microstructure during solidification of MMCs is mainly influenced by four factors: nucleation (or its absence) o...
متن کاملComparison of cavitation erosion rate with liquid impingement erosion rate
Both cavitation erosion and liquid impingement erosion are phenomena that can cause pipe wall thinning in power plants. The Code for Power Generation Facilities, Rules on Pipe Wall Thinning Management, was published by the JSME (Japan Society of Mechanical Engineers) in 2005. The code says that cavitation erosion shall be prevented either in the design stage or by daily inspection. On the other...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1992
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.58.909