Catalytic Converter with Storage Device of Exhaust Gas Heat for City Bus

Modeling Transport Phenomena in Selective Catalytic Reductant Catalytic Converter with NH3 as Reductant for NO Degradation

In the current study, reduction of nitrogen oxide from exhaust gas in the presence of NH3 as reductant on selective catalytic reductant (SCR) impregnated catalytic converter was simulated using Comsol© software. Mass transfer (one-dimensional) and heat transfer (three-dimensional) governing equations were taken into account to model the unsteady state behavior of the catalytic converter. Modeli...

Latent Heat Recovery in Exhaust Gas of a Condensing Boiler: The Effect of Arrangement of Tubes

Boilers are one of the major energy consumers in the building. For this reason, increasing the efficiency of this device and improving its performance is an effective step in solving the problems in building energy and reducing waste energy. Due to the limited resources of fossil fuels and the increasing cost of energy in the world, manufacturers of these equipment are always working to improve...

Modeling and Simulation of Different Gas Flows Velocity and Pressure in Catalytic Converter with Porous

Modeling And Simulation of Gas Flow Velocity In Catalytic Converter With Porous

Stringent emission regulations around the world necessitate the use of high-efficiency catalytic converters in vehicle exhaust systems. Experimental studies are more expensive than computational studies. Also using computational techniques allows one to obtain all the required data for the Catalytic Converter, some of which could not be measured. In the present work, Geometric modeling ceramic ...

A Numerical Study on Using Air Cooler Heat Exchanger for Low Grade Energy Recovery from Exhaust Flue Gas in Natural Gas Pressure Reduction Stations

Heat EXchangers (HEX) that are used in City Gate Station (CGS) systems are modeled numerically to recover the exhaust waste heat. It was tried to find the best viscous model to obtain results in accordance with experimental results and to change the heat exchanger design. This HEX is used for recovering heat from exhaust flue gas with a mixture of 40% water and 60% ethylene glycol as the coolin...