Cascode Low Noise Amplifier (LNA) with Negative Feedback for Long Term Evolution (LTE)
نویسندگان
چکیده
منابع مشابه
A Low Noise Cascode Amplifier
A low noise amplifier has been designed using a 2SK117 N channel J-FET as the input device in a cascode [1] configuration. Noise measurements on this amplifier yield a low frequency noise current of 0.25 fA/Yfu and a voltage noise of less than 1.2 n V NHz in the 500 Hz to 50 kHz region. Bloyet et al. [2] suggest a figure of merit of the product of the noise voltage and current as being appropri...
متن کاملWideband Low Noise Amplifier for Long Term Evolution Systems
This paper introduces wideband low noise amplifier design for Long Term Evolution systems. The three-stage, cascade wideband low noise amplifier structure will be presented. The low noise amplifier (LNA) is design for uplink channels for LTE systems. The LNA is designed for LTE receiver front-end which operates in 700-1300 MHz frequency range, covering almost entire LTE uplink frequency band. W...
متن کاملA 2.4GHz Cascode CMOS Low Noise Amplifier
A cascode CMOS low noise amplifier (LNA) is presented along with the used design methodology and measurement results. The LNA works at 2.4 GHz with 14.5 dB voltage gain and 2.8 dB simulated noise figure (NF). Powered from a 1.8 V supply, the core measured current consumption is 2.76 mA. An output buffer was designed to match a 50 Ω load and its current consumption is 5.5 mA. The technology used...
متن کاملAdjustable Gain Cascode Low Noise Amplifier
Tower mounted amplifiers (TMA) serve to lower the system noise figure (NF) in cellular base-stations. For performance reasons, the TMA is located as near to the receiving aerial as practical and has to be connected to the rest of the radio at the tower’s base by a long run of coaxial cable. The parameters critical to TMA performance are low NF for reasons of optimizing coverage area, high gain ...
متن کاملChannel Quality Indicator Feedback in Long Term Evolution (LTE) System
LTE is a 3GPP evolution of UMTS that is envisaged to provide high data rate and low latency in order to satisfy the data rate requirement of current high data rate applications. To achieve this and guaranty transmission at all times, LTE system adjust transmission parameters like PMI, RI and CQI dynamically. Accomplished via feedback from UE, the feedbacks are set after every transmission time ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2021
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/1051/1/012027