Cascaded-cladding-pumped cascaded Raman fiber amplifier
نویسندگان
چکیده
منابع مشابه
Compact, fiber-compatible, cascaded Raman laser.
Cascaded Raman Stokes lasing in an ultrahigh-Q silica microsphere resonator coupled to a tapered fiber is demonstrated and analyzed. With less than 900 microW of pump power near 980 nm, five cascaded Stokes lasing lines are generated. In addition, a threshold power of 56.4 microW for the first-order Stokes lasing is achieved. The Stokes lasing lines exhibit distinct characteristics depending on...
متن کاملFourth-order cascaded Raman shift in AsSe chalcogenide suspended-core fiber pumped at 2 μm.
Cascaded Raman wavelength shifting up to the fourth order ranging from 2092 to 2450 nm is demonstrated using a nanosecond pump at 1995 nm in a low-loss As(38)Se(62) suspended-core microstructured fiber. These four Stokes shifts are obtained with a low peak power of 11 W, and only 3 W are required to obtain three shifts. The Raman gain coefficient for the fiber is estimated to (1.6±0.5)×10(-11) ...
متن کاملRaman Amplification And Pulsed Lasing In Cladding-Pumped Germanosilicate Fiber
Introduction: Cladding-pumped rare-earth-doped fibers and Raman fiber devices have been two of the most compelling advances in the area of fiber amplifiers and lasers in recent years. Both cladding-pumped fibers and Raman fiber devices are primarily high-power devices. Cladding-pumping enables pumping with multi-mode pump sources that deliver high-power at a low cost. The core of the double-cla...
متن کاملSolid-core photonic bandgap fibers for cladding-pumped Raman amplification.
Cladding-pumped solid-core photonic bandgap Raman fiber amplifiers are analyzed theoretically as possible candidates for power scaling. An example fiber design with a mode field diameter of 46 µm and a cladding diameter of 250 µm is calculated to exhibit 0.12 dB/km of confinement loss at the first Stokes wavelength and >10 dB/m at the second Stokes wavelength for a pump wavelength of 1.567 µm w...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optics Express
سال: 2015
ISSN: 1094-4087
DOI: 10.1364/oe.23.013947