Carbon Control of Injection Molded 4600 Steels.
نویسندگان
چکیده
منابع مشابه
Characterization and Compression Properties of Injection Molded Carbon Nanotube Composites
Since the development of carbon nanotubes (CNTs) in 1991, they have received much attention with improved mechanical, thermal, and electrical properties of their composites compared to common polymer composites. The CNTs are currently used to increase the modulus of common thermoplastics and thermosets, including urethanes and epoxies. The CNTs are difficult to disperse within any media because...
متن کاملFiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملThermal Processing of Injection-Molded Silicon Carbide
Silicon carbide is the most important and versatile non-oxide ceramic. Powder injection molding (PIM) is a method of high-speed fabrication of complex near-net shapes of SiC and other powders. Green micro-machining (GMM) is used to extend the shaping capability of green ceramics and powder metallurgy to smaller feature sizes. Debinding—removal of organic additives—is the rate-limiting step in P...
متن کاملCharacterization and Compression Properties of Injection Molded Carbon Nanotube Composites By:
Since the development of carbon nanotubes (CNTs) in 1991, they have received much attention with improved mechanical, thermal, and electrical properties of their composites compared to common polymer composites. This study evaluated the effect of incorporating bundled and unbundled carbon nanotubes into Polyurethane/CNT/woven fiber reinforced composites. Atomic Force Microscopy (AFM) was used t...
متن کاملInjection Molded Millimeter-Wave Horn Array Antenna
This paper shows injection molded millimeter-wave horn array antenna for the 1-dimensional APAA(Active Phase Array Antenna). The antenna is composed of horn antennas, grooved circular waveguide polarizers, E-plane T-junctions, and E-plane bends employing dielectric waveguides. This structure makes it possible to manufacture a feed circuit and radiating elements as an integrated unit by using in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1991
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.38.767