منابع مشابه
Impact of Beam Thickness and Air Gap on the Performance of Cantilever MEMS Switch
This paper represents the impact of beam thickness and air gap upon the performance of cantilever MEMS switches having different beam materials (Al, Au metals). A comparative analysis of spring constant, effective mass, pull-in voltage, capacitance of cantilever based MEMS switch has been performed by 3D simulation using COMSOL Multiphysics based on Finite Element Method [FEM]. Different parame...
متن کاملCantilever beam electrostatic MEMS actuators beyond pull-in
The operational range of electrostatic MEMS parallel plate actuators can be extended beyond pull-in in the presence of an intermediate dielectric layer, which has a significant effect on the behavior of such actuators. Here, we study the behavior of cantilever beam electrostatic actuators beyond pull-in using a beam model along with a dielectric layer. The results from the simple beam model are...
متن کاملMems cantilever sensors pdf
S.Z. cantilevers are made using a simple one-mask fabrication process with.characterization of a cantilever-type MEMS chemical sensor for detection of chemicals. MEMS has been with the advancement of cantilever-type sensors.sensor. The mechanical structure is a cantilever, having its own resonant frequency. MEMS cantilevers can be as thin as a few nanometers with lengths.Cantilever-based Sensor...
متن کاملSurface roughness, asperity contact and gold RF MEMS switch behavior
Modeling predictions and experimental measurements were obtained to characterize the electro-mechanical response of radio frequency (RF) microelectromechanical (MEM) switches due to variations in surface roughness and finite asperity deformations. Three-dimensional surface roughness profiles were generated, based on a Weierstrass–Mandelbrot fractal representation, to match the measured roughnes...
متن کاملDesign and Simulation of Novel RF MEMS Cantilever Switch with Low Actuation Voltage
In this paper a novel RF MEMS cantilever type switch with low actuation voltage is presented. The cantilever beam of switch is supported by two L-shaped springs to reduce the spring constant. The switch is simulated using Intellisuite software. The actuation voltage of switch is achieved about 2 volt and the size of the switch is 110×60μm, that in compared with other electrostatic cantilever be...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Conference Papers in Engineering
سال: 2013
ISSN: 2314-5366
DOI: 10.1155/2013/265709