Calibration of an ultrasonic flow meter for hot water

A Curve-fitting Calibration Method applied for Ultrasonic Flow-meter

As the influence of fluid distribution in the internal pipe, the measurement characteristics of theory and practice exist significant differences in Ultrasonic Flow-meter (USF). Through analysis of fluid state, the method of curve-fitting is applied for the calibration of USF. Experimental results show that the USF can achieve level-1 accuracy with just a correction of 5 flow points, and this m...

In Line Flow-meter Calibration

Development and evaluation of an ultrasonic ground water seepage meter.

Submarine ground water discharge can influence significantly the near-shore transport and flux of chemicals into the oceans. Quantification of the sources and rates of such discharge requires a ground water seepage meter that provides continuous measurements at high resolution over an extended period of time. An ultrasonic flowmeter has been adapted for such measurements in the submarine enviro...

A Signal Pre-processing Algorithm Applied for Ultrasonic Flow-meter

In order to solve the problem of time difference ultrasonic flow meter’s low accuracy, against the basic characteristics of the sample data, a data-processing algorithm is proposed. First, we use shell sort do a data pre-processing to the samples, then remove the error of the sample space by complex digital filter, and use the error compensation algorithm to get the final sample results. Among ...

K V Santhosh: Fusion of Venturi and Ultrasonic Flow Meter for Enhanced Flow Meter Characteristics Using Fuzzy Logic

This paper proposes a technique for measurement of liquid flow using venturi and ultrasonic flow meter(UFM) to have following objectives a) to design a multi-sensor data fusion (MSDF) architecture for using both the sensors, b) improve sensitivity and linearity of venturi and ultrasonic flow meter and c) detect and diagnosis of faults in sensor if any. Fuzzy logic algorithm is used to fuse outp...