Calculation of a Direct-Flow Anthracite Culm Gasification Process with Liquid Slag Removal

نویسندگان

چکیده

Abstract A program for calculating the gasification process based on a mathematical model of direct-flow coal with liquid ash removal, in which mixture oxygen and water vapor is used as blast, considered. Calculations were carried out anthracite culm from Eastern Donbass basin raw material.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Thermodynamic Investigation of Copper Removal From Liquid Slag.

The removal of copper dissolved in liquid stags by pyrometalIurgical means such as gaseous reduction and sulfidization is thermodynamically investigated. The lowest level possible for copper content is theoretically determined and compared. The results show that gaseous reduction is not as effective as sulfidization. Slags with very low levels of dissolved copper can be obtained with sulfide tr...

متن کامل

Flow Pattern Identification and Pressure Drop Calculation for Gas-Liquid Flow in a Horizontal Pipeline

Two phase gas-liquid flow pattern in a horizontal pipeline is predicted very accurately using a newly-developed analytical relation. The pattern identification is based on one of the most widely used graphs, the Baker diagram, modified in a way that compensates for the unrealistic oversimplifications of recent works. The Kern's method of pressure drop calculation is used to obtain the frict...

متن کامل

CFD-Calculation of Fluid Flow in a

An accurate description of the fluid flow and heat transfer within a Pressurized Water Reactor (PWR), for the safety analysis and reactor performance is always desirable. In this paper a mathematical model of the fundamental physical phenomena which are associated to a typical PWR is presented. The mathematical model governs the fluid dynamics in the reactor. Using commercial software CFX, a co...

متن کامل

Removal of Phosphate Ions from Aqueous Solution Using Anthracite

Anthracite was used as an adsorbent to remove excess phosphate from wastewater. Anthracite used in the present study is environmentally friendly and of cost effective. The adsorption study was carried out using different particle size of adsorbents, different concentration of phosphate solution ranging from 25.0 mg/L to 100.0 mg/L, different pH values ranging from 0.5 to 11.5 along with differe...

متن کامل

Superstructure of Cogeneration of Power, Heating, Cooling and Liquid Fuels Using Gasification of Feedstock with Primary Material of Coal for Employing in LNG Process

Using absorption refrigeration cycles instead of vapor compression refrigeration cycles can drastically decrease energy consumption. In these systems, high level of energy consumption is reduced due to the partially elimination of vapor compression refrigeration systems. On the other hand, utilization of waste heat of the plant, which is a very good opportunity for energy saving,  is possible. ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Solid Fuel Chemistry

سال: 2022

ISSN: ['0361-5219', '1934-8029']

DOI: https://doi.org/10.3103/s0361521922060088