Calculating the Solar Energy of a Flat Plate Collector
نویسندگان
چکیده
منابع مشابه
Modeling of Flat-Plate Solar Collector Operation in Transient States
Saleh, Ahmad M. M.S.E., Purdue University, May 2012. Modeling Of Flat-Plate Solar Collector Operation in Transient States. Major Professor: Hosni Abu-Mulaweh. Solar energy is becoming an alternative for the limited fossil fuel resources. One of the simplest and most direct applications of this energy is the conversion of solar radiation into heat, which can be used in water heating systems. A c...
متن کاملEnergy, economic and environmental analysis of metal oxides nanofluid for flat-plate solar collector
For a solar thermal system, increasing the heat transfer area can increase the output temperature of the system. However, this approach leads to a bigger and bulkier collector. It will then increase the cost and energy needed to manufacture the solar collector. This study is carried out to estimate the potential to design a smaller solar collector that can produce the same desired output temper...
متن کاملSensitivity Analysis of the Test Parameters of a Solar Flat Plate Collector for Performance Studies
The BIS test procedure for performance of solar flat plate collectors allows a certain limit of deviation for the control parameters to define the steady state condition. During actual performance studies, sometimes these limits are exceeded. In this paper an attempt has been made to find out the effect on the performance curve of the collector as a result of exceeding this prescribed limit by ...
متن کاملexergy analysis of a flat plate solar collector in combination with heat pipe
the use of solar collectors in combination with heat pipes is rapidly growing in recent years.heat pipes, as heat transfer components, have undeniable advantages in comparison with other alternatives. the most important advantage is their high rate of heat transfer at minor temperature differences. although there have been numerous studies on the heat analysis or first thermodynamic analysis of...
متن کاملdesign, construction and evaluation of solar flat-plate collector simulator based on the thermohydraulic coefficient
introduction increasing the area of absorber plate between the flowed air through the duct can be accomplished by corrugating the absorber plate or by using the artificial roughness underside of the absorber plate as the commercial methods for enhancing the thermohydraulic performance of the flat plate solar air heaters. evaluation of this requires the construction of separated solar air heater...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Undergraduate Journal of Mathematical Modeling: One + Two
سال: 2014
ISSN: 2326-3652
DOI: 10.5038/2326-3652.6.1.4857