Calcium titanate ceramics obtained by combustion synthesis and two-step sintering
نویسندگان
چکیده
منابع مشابه
Synthesis of Barium-zinc-titanate Ceramics
Mixtures of BaCO3, ZnO and TiO2 powders, with molar ratio of 1:2:4, were mechanically activated for 20, 40 and minutes in a planetary ball mill. The resulting powders were compacted into pellets and isothermally sintered at 1250 °C for 2h with a heating rate of 10 °C/min. X-ray diffraction analysis of obtained powders and sintered samples was performed in order to investigate changes of the pha...
متن کاملProcessing of hydroxyapatite obtained by combustion synthesis
One of the reasons of implants failure are the stress forces appearing in the material–tissue interface due to the differences between their mechanical properties. For this reason, similar mechanical properties to the surrounding tissue are desirable. The synthesis of hydroxyapatite by solution combustion method and its processing have been studied in order to obtain fully dense ceramic bodies ...
متن کاملSintering of Ceramics
Sintering with low frequency rf power (-50 M H z ) is a new technique with unique capabilities that has been used to sinter a variety of ceramic materials, including zirconia-toughened alumina, alumina, silicon carbide, and boron carbide. Processing with low frequencies offers many advantages compared to processing with conventional microwave frequencies (915 MHz and 2.45 GHz). Because of the l...
متن کاملOptimization of Sintering Temperature for Maximizing Dimensionless Figure of Merit of La-Doped Strontium Titanate Thermoelectric Material in the Combination of Combustion Synthesis with Post Spark Plasma Sintering
This paper describes thermoelectric properties of La-doped SrTiO3 prepared by using a combination of combustion synthesis (CS) with post spark plasma sintering (SPS), on which effects of sintering temperature were mainly examined. In experimental, combustion-synthesized (CSed) samples (Sr1 xLaxTiO3, x 1⁄4 0:08) were spark-plasma-sintered (SPSed) at temperatures from 1513 to 1663K and the thermo...
متن کاملPractical classes " Ceramics & Colloids " : TP 3 Sintering 1 TP 3 - Ceramics : Sintering and Microstructure
After the initial molding of the ceramic, whether by slip casting or dry pressing, it is still necessary to densify the compacted powder samples (green bodies) to form a continuous 3D structure and thus to get ceramic pieces appropriate for the selected application. Usually this is done by a sintering process which is a consolidation and densification step of the granular compact through the ac...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science of Sintering
سال: 2020
ISSN: 0350-820X,1820-7413
DOI: 10.2298/sos2004491m