Buckling of a compliant hollow cylinder attached to a rotating rigid shaft
نویسندگان
چکیده
منابع مشابه
Thermoelastic Response of a Rotating Hollow Cylinder Based on Generalized Model with Higher Order Derivatives and Phase-Lags
Generalized thermoelastic models have been developed with the aim of eliminating the contradiction in the infinite velocity of heat propagation inherent in the classical dynamical coupled thermoelasticity theory. In these generalized models, the basic equations include thermal relaxation times and they are of hyperbolic type. Furthermore, Tzou established the dual-phase-lag heat conduction theo...
متن کاملAnalysis of Flow Past a Cylinder Attached to a Spring
The flow of fluid past a cylinder has been widely studied both analytically and numerically, and provides insight to the behavior of flow given different fluid properties. Particularly interesting is the transition from steady flow to vortex shedding in the wake of the cylinder. This behavior is dependent on several parameters, but most importantly, the Reynolds number (Re), which is a dimensio...
متن کاملDevelopment of a novel method in TRMC for a Binary Gas Flow Inside a Rotating Cylinder
A new approach to calculate the axially symmetric binary gas flow is proposed Dalton’s law for partial pressures contributed by each species of a binary gas mixture (argon and helium) is incorporated into numerical simulation of rarefied axially symmetric flow inside a rotating cylinder using the time relaxed Monte-Carlo (TRMC) scheme and the direct simulation Monte-Carlo (DSMC) method. The res...
متن کاملExperimental study of quenching process on a rotating hollow cylinder by one row of impinging jets
Quenching cooling rate of rotary hollow cylinder by one row of water impinging jets has been experimentally studied. Water jets (d = 8 mm) with sub-cooling 55 to 85 ◦C and Reynolds number 8,006 to 36,738 impinged over rotary hot hollow cylinder (rotation speed 10 to 70 rpm) with initial temperature 250 to 600 ◦C. Impingement impact angle of row of jets varied between 0 to 135 ◦ and jet-to-jet s...
متن کاملContinuous Heating of a Hollow Cylinder*
7. The essence of the method of characteristics is the following. Suppose the flow is to be determined in the channel of Fig. 4 and the flow is known up to the line I. Select points A and B on line I. At these points the velocity, the direction of flow, etc., is known. Thus characteristics Ca and Cb can be drawn. Equation (17) used along the two different characteristics gives two equations for...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Solids and Structures
سال: 2019
ISSN: 0020-7683
DOI: 10.1016/j.ijsolstr.2019.03.010