Bubble size distribution and energy dissipation in foam mixers
نویسندگان
چکیده
منابع مشابه
Dissipation in a sheared foam: from bubble adhesion to foam rheology.
The link between the rheology of 3D aqueous foam and the adhesion of neighboring bubbles is tested by confronting experiments at two different length scales. On the one hand, the dynamics of adhesion are probed by measuring how the shape of two bubbles in contact changes as their center-to-center distance is modulated. On the other hand, the linear viscoelastic behavior of 3D foam prepared with...
متن کاملInteractional effects of bubble size, particle size, and collector dosage on bubble loading in column flotation
The success of flotation operation depends upon the thriving interactions of chemical and physical variables. In this work, the effects of particle size, bubble size, and collector dosage on the bubble loading in a continuous flotation column were investigated. In other words, this work was mainly concerned with the evaluation of the true flotation response to the changes in the operating varia...
متن کاملInviscid dynamics of a wet foam drop with monodisperse bubble size distribution
Motivated by recent experiments involving the acoustic levitation of foam drops, we develop a model for nonlinear oscillations of a spherical drop composed of monodisperse aqueous foam with void fraction below 0.1. The model conceptually divides a foam drop into many cells, each cell consisting of a spherical volume of liquid with a bubble at its center. By treating the liquid as incompressible...
متن کاملFoam Generation in Rotor-Stator Mixers
non-ideality, it will tend to reduce differences between calibraiion and predictior;. To do this of course is not always possible, particularly where the effect of changing dyebath conditions is under consideration, e.g. liquor ratio, electrolyte concentration, pH and dye concentration. To attempt calibration experiments to adequately cover the results of such changes would remove the need for ...
متن کاملCompressibility and Foaming behavior of steel slag/waste glass compositesby particle size distribution and foam agents
In present research, the foam glass-ceramic composites fabricated by window glass, steel slag and SiC, CaCO3 foaming agents were investigated by press–sintering method. The optimum sintering temperature was obtained at 1200°C with a 3-minutes holding time and 20°C/min heating rate. The optimum pressure level of 80 MPa for achieving the 70 % of relative density was selected. The effec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Dyers and Colourists
سال: 2008
ISSN: 0037-9859
DOI: 10.1111/j.1478-4408.1987.tb01090.x