Brillouin-Erbium fiber laser with enhanced feedback coupling using common Erbium gain section

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Enhanced S-band Brillouin Erbium Fiber Laser with Additional Edfa

A short wavelength band Brillouin Erbium Fiber Laser (S-band BEFL) with enhanced characteristics using an additional erbium-doped fiber amplifier (EDFA) in the sub-loop of the BEFL system. Compared with the conventional BEFL without the additional EDFA, the enhanced BEFL has improved the number of channels as well as the flatness of the Brillouin Stoke’s peak power. By incorporating a double-pa...

متن کامل

Optimization of output coupling ratio on the performance of a ring-cavity Brillouin-erbium fiber laser.

The operation of a single-wavelength Brillouin-erbium fiber laser (BEFL) system with a Brillouin pump preamplified technique for different output coupling ratios in a ring cavity is experimentally demonstrated. The characteristics of Brillouin Stokes power and tunability were investigated in this research. The efficiency of the BEFL operation was obtained at an optimum output coupling ratio of ...

متن کامل

High Gain Erbium Doped Fiber Amplifiers

Performance improvements by using an isolator as an amplified spontaneous emission suppressing component within erbium-doped fibers are evaluated. Simultaneous high-gain and near-quantum-limited noise figures can be obtained by such a scheme. The noise figure improves for input signal powers below -5 dBm and an improvement of 2.0 db with a simultaneous gain increase of 4.1 dB is measured relati...

متن کامل

Tunable range enhancement of Brillouin-erbium fiber laser utilizing Brillouin pump pre-amplification technique.

We demonstrate an enhanced multiwavelength L-band Brillouin-erbium fiber laser (BEFL), in which the Brillouin pump is pre-amplified before entering the single-mode fiber. The Brillouin pump pre-amplification provided by the Erbium-doped fiber has created higher intensity of Brillouin Stokes line generated in the single-mode fiber that leads to the homogenous gain saturation. Thus the built-up o...

متن کامل

Brillouin signal amplification in pumped erbium-doped optical fiber

Amplification of Brillouin scattering signal extends the measurement range and improves the signal-to-noise ratio of fiber-optic distributed Brillouin sensors. Here, we investigate the amplification effect of a 980-nm pump laser on Brillouin gain spectrum in an erbium-doped optical fiber. The Brillouin-scattered Stokes power increased exponentially with increasing pump power, exhibiting approxi...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Optics Express

سال: 2008

ISSN: 1094-4087

DOI: 10.1364/oe.16.016475