Bridge-Connected Magnetic Circuit Using Cut Cores, with Application to a Variable Inductor.
نویسندگان
چکیده
منابع مشابه
An Electrical Circuit Model for Magnetic Cores
In Figure 2, the shape is the same as Fig. I, but the axis labels and values have been changed. Figure 2 shows the characteristic of a specific core made from the material of Figure I. The flux density axis Magnetic Fundamentals: Units commonly used in magnetics design are given in Table I, along with conversion factors from the older CGS system to the SI system (sysfeme infernationalrationaliz...
متن کاملWide Tuning Range LC-VCO Using Variable Inductor for Reconfigurable RF Circuit
This paper presents a novel wide tuning range CMOS Voltage Controlled Oscillator (VCO). VCO uses an on-chip variable inductor as an additional variable element to extend the tuning range of VCO. The fabricated variable inductor achieves the variable range of 35%. The VCO was fabricated using 0.35 μm standard CMOS process, and can be tuned continuously from 2.13 GHz to 3.28 GHz (tuning range of ...
متن کاملa new type-ii fuzzy logic based controller for non-linear dynamical systems with application to 3-psp parallel robot
abstract type-ii fuzzy logic has shown its superiority over traditional fuzzy logic when dealing with uncertainty. type-ii fuzzy logic controllers are however newer and more promising approaches that have been recently applied to various fields due to their significant contribution especially when the noise (as an important instance of uncertainty) emerges. during the design of type- i fuz...
15 صفحه اولA Synthetic Inductor Implementation of Chua's Circuit
We show how to build an inductorless version of the classic Chua’s circuit. The goal is to build Chua’s circuit quickly and easily. To this end, only off-the-shelf components are used. A suitable inductor for Chua’s circuit is often hard to procure. Here, the inductor is replaced by a single op-amp synthetic inductor circuit. The synthetic inductor is novel in the sense that it is not a gyrator...
متن کاملDesign and Simulation of Voltage Booster Circuit Using Coupled Inductor
In this paper, a high voltage gain of DC-DC converter with design and simulation are proposed using coupledinductor. The proposed converter duty ratio is 0.65, so appropriate duty ratio is considering for this design of the converter. Due do more number of switches are considers for the converter circuit will make more switching power losses but in this converter using only two switches and hav...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 2003
ISSN: 0285-0192
DOI: 10.3379/jmsjmag.27.570