Brake Squeal Analysis using Finite Element Analysis Method
نویسندگان
چکیده
منابع مشابه
Instability prediction of brake squeal by nonlinear stability analysis
ABSTRACT Prediction of brake squeal as unwanted high frequency noise above 1 kHz remains a challenging problem despite substantial research efforts in the past two decades. Brake squeal, triggered by friction-induced self-excited vibration, can be caused by many different and interacting mechanisms with nonlinear origins in material properties and boundary conditions. Although brake squeal is e...
متن کاملNumerical analysis of automotive disc brake squeal: a review
This paper reviews numerical methods and analysis procedures used in the study of automotive disc brake squeal. It covers two major approaches used in the automotive industry, the complex eigenvalue analysis and the transient analysis. The advantages and limitations of each approach are examined. This review can help analysts to choose right methods and make decisions on new areas of method dev...
متن کاملFinite Element Analysis Of Disc Brake By ANSYS Workbench
The brakes must be strong enough to stop the vehicle within a minimum distance in an emergency. The driver must have proper control over the vehicle during emergency braking and vehicle must not skid. The brakes must have good antedate characteristics their effectiveness should not decrease with prolonged application and thus it demand that the cooling of the brakes should be very efficient. Fo...
متن کاملA Proposed Modeling Method in Finite Element Slope Stability Analysis
Limit-equilibrium method (LEM) and finite element method (FEM) with strength reduction method (SRM) techniques are the most widely used analysis tools in slope stability assessment. Recently, researchers have reported that both factor of safety (FOS) values and failure surfaces obtained from LEM and FEM are generally in good agreement, except in some particular cases. In this paper, the FOS and...
متن کاملCorrecting the stress-strain curve in hot compression test using finite element analysis and Taguchi method
In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Engineering Sciences
سال: 2020
ISSN: 0976-6693
DOI: 10.36224/ijes.130301