Bonding Characteristics of Cold Sprayed Copper Coating on Alumina coated Q235 Steel Substrate
نویسندگان
چکیده
منابع مشابه
Corrosion of Cold Spray Deposited Copper Coating on Steel Substrates
The corrosion behavior of copper cold spray coatings on a carbon steel substrate was compared to that of commercially available wrought copper under the conditions anticipated in a nuclear waste repository. Corrosion potential and linear polarization resistance measurements were conducted over 90 d to 120 d in 3.0 mol/L NaCl under anoxic (1) and oxygenated-toanoxic (2) conditions to simulate th...
متن کاملPost Heat Treatment of Plasma Sprayed Pure and Alumina-Titania Reinforced Hydroxyapatite Coating on SS 304 Steel
It has been reported by previous research work that in plasma spray process hydroxyapatite decomposes into some amorphous phases due to rapid cooling of the coated substrate during the coating process, which causes instability of coated implant. Post coating heat treatment has been expected to minimize these phases and also enhance the long term reliability of hydroxyapatite coatings on metal s...
متن کاملSliding-induced Microstructure of Cold-Sprayed Copper Coating Observed by Electron Channeling Contrast Imaging
Cold gas dynamic spray is a coating process for fabrication of materials that are sensitive to heat and oxidation such as copper [1]. In cold spray, the particles are accelerated to supersonic velocities typically between 500 1200 m/s [1]. Upon high speed impact, the cold sprayed particles undergo extensive plastic deformation at very high strain-rates (up to 10 9 s -1 near impact interfaces), ...
متن کاملComposition Distribution and Electrochemical Behavior of an Ni2Al3 Coating on Q235 Steel
An Ni2Al3 coating was prepared via the electrodeposition of nickel followed by pack aluminization. Polarization curve and electrochemical impedance spectroscopy were performed to study the room temperature corrosion behavior of the coating in a 3.5 wt. % NaCl solution. The long-term impedance of the coating was also investigated after immersion for 30 days. Results show that the Ni2Al3 coating ...
متن کاملTransmission electron microscopy of cold sprayed 1100 aluminum coating
Cold-spraying of 1100 Al powder particles onto 1100 Al substrate was accomplished using carrier gases 100 vol.% He and a mixture of He–20 vol.% N2. TEM characterization correlates very well the occurrence of dislocations, presence of oxide, and surface instability phenomenon with observed mechanical and corrosion properties of the cold-sprayed coating. 2005 Acta Materialia Inc. Published by Els...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science
سال: 2021
ISSN: 2029-7289,1392-1320
DOI: 10.5755/j02.ms.25326