Bond Characteristics of Ultra High Performance Concrete
نویسندگان
چکیده
منابع مشابه
Ultra High Performance Self Compacting Concrete
Experiences in the development of Ultra High Performance Concrete found a very high flowability in concrete with low water powder ratio. Because of the high viscosity of the cement paste, compaction was necessary. To improve the compaction characteristics of the concrete the idea of adding coarse aggregate was developed. The first tests showed a good workability of the fresh concrete and a good...
متن کاملEffect of Reinforcement Type on the Tension Stiffening Model of Ultra-High Performance Concrete (UHPC)
Ultra-high performance concrete (UHPC) is a developing concrete and today is increasing to interest using it in structures due to its advantages such as high-compressive strength, modulus of elasticity, highly durability and low-permeability. Therefore, it is necessary to provide models for prediction of nonlinear behavior of this material. This study is aimed to investigate the tension-stiffen...
متن کاملDynamic Shear Energy Absorption of Ultra-High Performance Concrete
The exemplary mechanical performance and durability of ultra-high performance concrete (UHPC) has led to its rapid emergence as an advanced cementitious material. The uncharacteristically high mechanical strength and ductility of UHPC makes it a promising potential material for defense structures which may be subject to highly dynamic loads like impact or blast. However, the mechanical response...
متن کاملBond of Reinforcement in High-Strength Concrete
This paper describes an examination of the development of tension lap splices in high-strength concrete and the applicability of the restriction in the ACI 318 code where the values of √fc′ used to calculate development length shall not exceed 100 psi. The focus is on the development of splices with Grade 60 epoxy-coated and uncoated bars in normalweight concrete. A summary of the behavior of b...
متن کاملBond of High Strength Concrete with High Strength Reinforcing Steel
This paper presents a study about the bond of high strength concrete with high strength steel. Fourteen pull out tests were carried out to determine the bond. The concrete strength was about 70 MPa and the steel was a 500 MPa grade. Bar diameters used were 12, 16, 20, 25, 28, 32 and 36 mm. In order to investigate the effect of cover, each test was done twice, once in a 240 mm diameter concrete ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korea Concrete Institute
سال: 2010
ISSN: 1229-5515
DOI: 10.4334/jkci.2010.22.6.753