Boiling of Superheated Drops in an Immiscible Liquid Medium
نویسندگان
چکیده
منابع مشابه
Boiling Heat Transfer Characteristics of Immiscible Liquid Mixtures
Cooling technology becomes more important because of the increase in heat generation density of semiconductor chips. Boiling and two-phase flow is expected as one of the most effective methods to cool the electronic devices because of its superior heat transfer characteristics. Because the boiling heat transfer depends on the selection of coolant, the development of liquid mixtures and their co...
متن کاملBubble Nucleation in Superheated Liquid-Liquid Emulsions
An investigation of the process by which bubbles form in superheated liquid-liquid emulsions is reported. A theoretical model for the rate of bubble nucleation is developed that is valid for any binary liquid system. Because of the interesting "microexplosion" phenomenon postulated to occur during combustion of fuel/water emulsions, special attention is focused on hydrocarbon/ water/surfactant ...
متن کاملElectrowetting-Induced Droplet Movement in an Immiscible Medium
This paper describes and characterizes the electrowetting-induced movement of droplets in an immiscible medium. When an aqueous droplet undergoes electrowetting-induced motion in a continuous phase of olive oil, the droplet glides through the olive oil at a much higher velocity than is possible in the absence of oil and is able to travel greater than 10 times the electrode separation distance. ...
متن کاملGamma ray Sensitivity of Superheated Liquid
INTRODUCTION The superheated drop detector (SDD) is composed of droplets of a sensitive liquid with low-boiling point and a medium supporting the droplets dispersed throughout the medium. The SDD has been mainly used for neutron dosimetry and recently also for γ -rays. However the conditions of bubble formation have been discussed for neutrons but there have been a little works for gamma-rays. ...
متن کاملImpact of drops on the surface of immiscible liquids.
Impact of drops on the surface of an immiscible liquid is studied. We show that in addition to the commonly-observed lens structure at the air-liquid interface, drops released from critical heights above the target liquid can sustain the impact and at the end maintain a spherical ball-shape configuration above the surface despite undergoing large deformation. The existence of this metastable st...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1974
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.40.507