Boiler Bypass Flue to Adjust Denitration Inlet Flue Temperature Automatic Control System Design and Analysis
نویسندگان
چکیده
منابع مشابه
Modeling and Simulation of Complex Fluid Networks in the Flue Gas System of a Boiler
Abstract: Under the conditions of high demand for energy saving and environmental protection, the thermal power unit is required to phase out the traditional extensive operation mode—a method of oxygen-enriched combustion in a furnace, considering safety first. Achieving efficient and economic operation with an optimal proportion of air distribution in these thermal power units is crucial. The ...
متن کاملFlue Gas Conditioning
Flue gas conditioning (FGC) systems offer an effective option for control of Particulate Matter (PM) emissions and enhances the performance of the Electrostatic Precipitators (EPs) when using coal of different properties. The increasing environmental awareness and the mandate of the Environmental Protection Agencies (EPA) in various countries to thermal power stations using coal-fired boilers f...
متن کاملFlue Gas Cooling
When waste heat is not utilized, cooling of flue gases in special cooling chambers becomes necessary, if the dust':'collecting and associated equipment is constructed of metal. The two most common methods of cooling are by dilution with ambient air, and by evaporation of water in the gas stream. Usually, they are combined. Load sharing depends largely on acceptable visibility of stack effluvia ...
متن کاملEffects of Flue Gas Internal Recirculation on NOx and SOx Emissions in a Co-Firing Boiler
Volumetric combustion has been developed to realize a high substitution ratio of biomass in co-firing boilers, which features an intensive flue gas internal recirculation inside furnace. However, the characteristics of NOx and SOx emissions in large-scale boilers with volumetric combustion were not fully clear. In this paper, an Aspen Plus model of volumetric combustion system was built up base...
متن کاملFlue gas desulfurization
Flue gas desulfurization is commonly known as FGD and is the technology used for removing sulfur dioxide (SO2) from the exhaust combustion flue gases of power plants that burn coal oroil to produce steam for the turbines that drive their electricity generators. The most common types of FGD contact the flue gases with an alkaline sorbent such as lime or limestone. As sulfur dioxide is responsibl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: DEStech Transactions on Environment, Energy and Earth Sciences
سال: 2021
ISSN: 2475-8833
DOI: 10.12783/dteees/peees2020/35487