Blown bubble-spinning for fabrication of superfine fibers
نویسندگان
چکیده
منابع مشابه
Fabrication of κ-Carrageenan Fibers by Wet Spinning: Spinning Parameters
This study demonstrates the fabrication of κ-carrageenan fibers by a wet-spinning method and discusses three important spinning parameters: coagulation bath composition, spinning rate and post-spinning mechanical drawing. The as-spun fiber diameter decreased with KCl and ethanol concentration in the coagulation bath. In general, the ultimate tensile stress and elongation at break both increased...
متن کاملFabrication of Nanoporous Fibers via Bubble Electrospinning
Recently, nanoporous fibers have been caught much attention as the most promising material in nanotechnology. To our knowledge, nanoporous materials have extremely high surface area and are widely used in different fields, such as filtration, radiation protection, catalysis, sensors, tissue engineering, and drug delivery [1-2]. Electrospinning is an effective method, which can fabricate polymer...
متن کاملFABRICATION OF CARBON FIBERS FROM COMMERCIAL WET SPIN POLYACRYLONITRILE FIBERS
Carbon fibers are fabricated from different materials such as special polyacrylonitrile (PAN) fibers, cellulose fibers and pitch. But PAN fibers are recognized as the most widely used precursor for the present-day manufacture of carbon fibers. The process of fabrication carbon fibers from special PAN fibers is composed of two steps including oxidative stabilization at low temperature and carbon...
متن کاملNanomaterial-incorporated blown bubble films for large-area, aligned nanostructures
Developing flexible and scalable methods for controlled assembly of nanomaterials remains a critical challenge in nanotechnology. In this article, we review the progress in assembly of nanostructures with a focus on the recently reported method utilizing a bubble expansion process to align one-dimensional nanostructures embedded in blown bubble films. This approach is general and enables effici...
متن کاملFabrication of Defect-Free Cellulose Acetate Hollow Fibers by Optimization of Spinning Parameters
Spinning of cellulose acetate (CA) with the additive polyvinylpyrrolidone (PVP) in N-methyl-2-pyrrolidone (NMP) solvent under different conditions was investigated. The spinning parameters of air gap, bore fluid composition, flow rate of bore fluid, and quench bath temperature were optimized based on the orthogonal experiment design (OED) method and multivariate analysis. FTIR and scanning elec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Thermal Science
سال: 2012
ISSN: 0354-9836,2334-7163
DOI: 10.2298/tsci1205465d