Blast wave energy absorbing systems made using a 3D printing technique – preliminary research
نویسندگان
چکیده
منابع مشابه
Study of Blast Wave – Structure Interaction Using Exploding Wires Technique
Over the last decades there has been an ever increasing effort to better predict the load developed on a structure in explosion events. During the passing time, the computational abilities dramatically improved and the ability to predict quantitative results for complex scenarios became achievable. However, the need to validate the obtained numerical results became a necessity. The validation c...
متن کاملAnkle-Foot Orthosis Made by 3D Printing Technique and Automated Design Software
We described 3D printing technique and automated design software and clinical results after the application of this AFO to a patient with a foot drop. After acquiring a 3D modelling file of a patient's lower leg with peroneal neuropathy by a 3D scanner, we loaded this file on the automated orthosis software and created the "STL" file. The designed AFO was printed using a fused filament fabricat...
متن کامل3d-printing of Energy Devices Using Particle-based Inks
Introduction and Summary Over the past year, ISEN funding has been utilized to make significant research progress towards the fabrication of a fully 3D-printed iron/solid oxide fuel cell (Metallic/multi-ceramic) batterygenerator system (Figure 1). Monies have gone towards the partial funding of one grad student/postdoc, Adam Jakus, in Ramille Shah’s Tissue Engineering and Additive Manufacturing...
متن کامل3d Woven Composites for Energy Absorbing Applications
Due to the presence of through-thickness reinforcement, 3D woven composites have superior fracture toughness, fatigue life, and damage tolerance compared to laminated composites. Furthermore, 3D woven composites exhibit a progressive damage behavior which is more benign than the typical catastrophic failure behavior of laminated composites. These properties lead to high specific energy absorpti...
متن کاملHydroxyapatite scaffolds for bone tissue engineering made by 3D printing.
Nowadays, there is a significant need for synthetic bone replacement materials used in bone tissue engineering (BTE). Rapid prototyping and especially 3D printing is a suitable technique to create custom implants based on medical data sets. 3D printing allows to fabricate scaffolds based on Hydroxyapatite with complex internal structures and high resolution. To determine the in vitro behaviour ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materiały Wysokoenergetyczne / High Energy Materials
سال: 2020
ISSN: 2083-0165
DOI: 10.22211/matwys/0195