منابع مشابه
Investigating Flank Wear and Cutting Force on Hard Steels by CBN Cutting Tool by Turning
In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...
متن کاملEffects of Friction and Cutting Speed on Cutting Force
Observations are made regarding the influence of cutting speed and friction on cutting force by way of finite element modeling. Simulations are validated by comparison of cutting forces and chip morphologies for the Al6061-T6. Analysis of cutting forces over a wide range of cutting conditions suggests an important role of the secondary shear zone in the decrease of cutting force as a function o...
متن کاملCombining fuzzy RES with GA for predicting wear performance of circular diamond saw in hard rock cutting process
Predicting the wear performance of circular diamond saw in the process of sawing hard dimensional stone is an important step in reducing production costs in the stone sawing industry. In the present research work, the effective parameters on circular diamond saw wear are defined, and then the weight of each parameter is determined through adopting a fuzzy rock engineering system (Fuzzy RES) bas...
متن کاملInfluence of machining cycle of horizontal milling on the quality of cutting force measurement for the cutting tool wear monitoring
The cutting tools are today used a lot by industry and they are expensive, so it was interesting to optimize their use, by developing a predictive method of their wear, particularly, the flank wear Vb. For this task, the flank tool wear was measured in off-line using a binocular microscope, whereas, the cutting forces are recorded by means of a dynamometer (Kistler 9255B). The acquired signatur...
متن کاملThe Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Shigen-to-Sozai
سال: 1999
ISSN: 0916-1740,1880-6244
DOI: 10.2473/shigentosozai.115.669