Beyond PDMS: off-stoichiometry thiol–ene (OSTE) based soft lithography for rapid prototyping of microfluidic devices
نویسندگان
چکیده
منابع مشابه
Beyond PDMS: off-stoichiometry thiol-ene (OSTE) based soft lithography for rapid prototyping of microfluidic devices.
In this article we introduce a novel polymer platform based on off-stoichiometry thiol-enes (OSTEs), aiming to bridge the gap between research prototyping and commercial production of microfluidic devices. The polymers are based on the versatile UV-curable thiol-ene chemistry but takes advantage of off-stoichiometry ratios to enable important features for a prototyping system, such as one-step ...
متن کاملEfficient prototyping of large-scale pdms and silicon nanofluidic devices using pdms-based phase-shift lithography
In this study, we explore the potential of Poly-DiMethylSiloxane (PDMS)-based phase shift lithography (PPSL) for the fabrication of nanofluidic devices. We establish that this technology, which was already shown to allow for the generation of 100 nm linear or punctual features over cm surfaces with conventional photolithography systems, is readily adequate to produce some of the most popular na...
متن کاملFLASH: a rapid method for prototyping paper-based microfluidic devices.
This article describes FLASH (Fast Lithographic Activation of Sheets), a rapid method for laboratory prototyping of microfluidic devices in paper. Paper-based microfluidic devices are emerging as a new technology for applications in diagnostics for the developing world, where low cost and simplicity are essential. FLASH is based on photolithography, but requires only a UV lamp and a hotplate; n...
متن کاملPolymer embossing tools for rapid prototyping of plastic microfluidic devices
In this paper, we describe a simple and rapid method of fabricating hot embossing tools using polydimethylsiloxane (PDMS), which are then used to rapidly fabricate microchannels in polymethylmethacrylate (PMMA). A negative photoepoxy SU-8 or thick positive photoresist AZ4620 on silicon was used for molding during PDMS casting. Fabrication time of these PDMS tools was considerably less than thos...
متن کاملPolymer Embossing Tools for Rapid Prototyping of Plastic Microfluidic Devices
In this work, a new MEMS technology for hot embossing using polydimethylsiloxane (PDMS) tools is developed and characterized. The developed technology will permit low cost, simple, and rapid fabrication of disposable microfluidic biochips and plastic microstructures for numerous BioMEMS applications. For traditional planar systems, a negative photoepoxy (SU-8) or thick positive photoresist (AZ4...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Lab on a Chip
سال: 2011
ISSN: 1473-0197,1473-0189
DOI: 10.1039/c1lc20388f