Bending Under Tension Test with Direct Friction Measurement

Damage Detection of Carbon Fiber-reinforced Concrete Under Bending Test

Direct measurement of friction of a fluctuating contact line.

We report a direct measurement of the friction coefficient of a fluctuating (and slipping) contact line using a thin vertical glass fiber of diameter d with one end glued onto a cantilever beam and the other end touching a liquid-air interface. By measuring the broadening of the resonant peak of the cantilever system with varying liquid viscosity η, we find the friction coefficient of the conta...

Combined Plastic Bending and Compression or Tension

So far we have assumed that a plastic hinge forms if the bending moment in a critical cross section reaches the plastic limit value, M0. We have tacitly neglected the effect of the other internal forces on the formation of the yield hinge. This effect, however, can be appreciable, for example in multi-storey frames or frames with a large horizontal thrust where the axial forces are large. So, w...

Residual Ductility and Microstructural Evolution in Continuous-Bending-under-Tension of AA-6022-T4

A ubiquitous experiment to characterize the formability of sheet metal is the simple tension test. Past research has shown that if the material is repeatedly bent and unbent during this test (i.e., Continuous-Bending-under-Tension, CBT), the percent elongation at failure can significantly increase. In this paper, this phenomenon is evaluated in detail for AA-6022-T4 sheets using a custom-built ...

Effect of Bending Rigidity on the Knotting of a Polymer under Tension

A coarse-grained computational model is used to investigate how the bending rigidity of a polymer under tension affects the formation of a trefoil knot. Thermodynamic integration techniques are applied to demonstrate that the free-energy cost of forming a knot has a minimum at nonzero bending rigidity. The position of the minimum exhibits a power-law dependence on the applied tension. For knott...