Bending Mechanism for Piezoelectric Transducer
نویسندگان
چکیده
منابع مشابه
Aluminum Nitride Piezoelectric Micromachined Ultrasound Transducer Arrays
Air-coupled piezoelectric micromachined ultrasound transducer arrays, operating at ~190 kHz, have been fabricated utilizing an aluminum nitride piezoelectric layer. Improved fabrication processes have reduced the frequency variation seen in our previous work with single transducers resulting in arrays of transducers with resonant frequencies (fn) that match within the fractional half-power band...
متن کاملDynamic Electromechanical Coupling of Piezoelectric Bending Actuators
Abstract: Electromechanical coupling defines the ratio of electrical and mechanical energy exchanged during a flexure cycle of a piezoelectric actuator. This paper presents an analysis of the dynamic electromechanical coupling factor (dynamic EMCF) for cantilever based piezoelectric actuators and provides for the first time explicit expressions for calculation of dynamic EMCF based on arrangeme...
متن کاملOptimal energy density piezoelectric bending actuators
The design and analysis of piezoelectric actuators is rarely optimized for low mass applications. However, emerging technologies such as micro air vehicles, and microrobotics in general, demand high force, high displacement, low mass actuators. Utilization of generic piezoceramics and high performance composite materials coupled with intelligent use of geometry and novel driving techniques yiel...
متن کامل1-3 Piezoelectric Composites for High Power Ultrasonic Transducer Applications
In this paper, we demonstrated that 1-3 PZT/polymer composites, fabricated using PZT-4 ceramic and a polymer possessing a high glass transition temperature and low loss, can be used as high power ultrasonic transducer materials for high intensity focused ultrasound (HIFU) applications. The mechanical quality factor of the 1-3 composite with 64% ceramic volume fraction is over 200. The dielectri...
متن کاملDevelopment of piezoelectric bending actuators with embedded piezoelectric sensors for micromechanical flapping mechanisms
This paper presents the fabrication and the testing of piezoelectric unimorph actuators with embedded piezoelectric sensors which are meant to be used for the actuation of the Micromechanical Flying Insect (MFI). First the fabrication process of a piezoelectric bending actuator comprising a standard unimorph and a rigid extension is described together with the advantages of adding such an exten...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Advanced Trends in Computer Science and Engineering
سال: 2020
ISSN: 2278-3091
DOI: 10.30534/ijatcse/2020/5491.42020