Behavior of AISI SAE 1020 Steel Implanted by Titanium and Exposed to Bacteria Sulphate Deoxidizer
نویسندگان
چکیده
منابع مشابه
Chromium Recoil Implantation Into SAE 1020 Steel By Nitrogen Ion Bombardment
SAE 1020 is a widely used plain carbon steel, as mortar reinforcement in buildings and small machine parts. But aside from good mechanical properties, its surface suffer from severe corrosion and high wear rate, due to modest hardness. Chromium (Cr) in excess of 12% in Fe alloys renders them resistant to several corrosive attacks. So we tried to introduce Cr in such amounts into the surface of ...
متن کاملIsothermal and cyclic oxidation behavior of AISI 430 ferritic stainless steel coated with titanium
In order to improve the oxidation resistance of ferritic stainless steel, it is possible to deposit a protective coating on steel substrate. In this research through the usage of pack cementation method a coating of titanium was applied on the surface of AISI 430 stainless steel. Scanning Electron-Microscopy (SEM), Energy- Dispersive X-ray spectrometry (EDAX) and X-ray diffraction (XRD) were us...
متن کاملEffects of Pretreatment Prior to Electroless Ni-P Plating on Fatigue Behavior of SAE 1045 Steel
Electroless Ni-P (EN) plating, as an important group of metallic coatings, employed in a wide range of industrial applications. The current work aims to investigate the effects of pretreatment process before EN plating on fatigue behavior of SAE 1045 steel. The specimens of rotating bending fatigue test were prepared from the steel in two series. A group of samples used in as-polished con...
متن کاملMicrostructure and mechanical properties evaluation of diffusion bonded joints of titanium to AISI 304 austenitic stainless steel
In this study, diffusion bonding between titanium and AISI 304 austenitic stainless steel by Ag interlayer was investigated. In order to carry out this research, samples prepared after surface preparation were placed inside the fixture and placed at the temperatures of 750,800 and 850 °C in the 30,60 and 90 min in the furnace under argon protective gas. The phase transformation and microstructu...
متن کاملMicrostructure and mechanical properties evaluation of diffusion bonded joints of titanium to AISI 304 austenitic stainless steel
In this study, diffusion bonding between titanium and AISI 304 austenitic stainless steel by Ag interlayer was investigated. In order to carry out this research, samples prepared after surface preparation were placed inside the fixture and placed at the temperatures of 750,800 and 850 °C in the 30,60 and 90 min in the furnace under argon protective gas. The phase transformation and microstructu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2014
ISSN: 1742-6596
DOI: 10.1088/1742-6596/511/1/012080