Bauschinger effect and back stress in a dual phase steel.
نویسندگان
چکیده
منابع مشابه
The Effect of Twinning and Slip on the Bauschinger Effect of Hadfield Steel Single Crystals
The Bauschinger effect (BE) in single crystals of Hadfield manganese steel (Fe, 12.3Mn, 1.0C in wt pct) was studied for three crystallographic orientations, [111], [123], and [001]. Both forward tensionreverse compression (FT/RC) and forward compression-reverse tension (FC/RT) loading schemes were used to investigate the role of deformation history on the BE. The evolution of stress-strain resp...
متن کاملStudy on Evaluation of Residual Phase Stress of the Dual Phase Stainless Steel
In this study , we measured residual stress in ground layer of ( CY+ r )dual phase stainless steel by X-ray diffraction. In addition, the influence of changing depth of cut on residual stress was investigated. It was found that residual stress in the a! phase was dependent on depth of cut, while the stress in Y phase was not affected by depth of cut. As a results of stress measurement under app...
متن کاملBauschinger effect in thin metal films
The Bauschinger effect in thin sputter-deposited Al and Cu films is studied by isothermally deforming the films alternately in tension and compression. Passivated films exhibit an unusual Bauschinger effect with reverse flow already occurring on unloading, while unpassivated films show little or no reverse flows when the film is fully unloaded. 2005 Acta Materialia Inc. Published by Elsevier Lt...
متن کاملFailure characteristics of a dual-phase steel sheet
Failure in ductile sheet metal structures is usually caused by one, or a combination of, ductile tensile fractures, ductile shear fractures or localised instability. In this paper the failure characteristics of the high strength steel Docol 600DP are explored. The study includes both experimental and numerical sections. In the experimental sections, the fracture surface of the sheet subjected t...
متن کاملImprovement of Mechanical Properties and Work-Hardening Behavior of Intercritically Annealed Dual Phase Steel
The effect of the initial microstructure and intercritical annealing on mechanical properties and work-hardening response of a high-formability low carbon steel were studied. The work-hardening analysis was based on the modified Crussard–Jaoul method. The ferritic-pearlitic sheets showed low strength and high total elongation with the appearance of the yield point phenomenon. The occurrence of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 1989
ISSN: 0915-1559
DOI: 10.2355/isijinternational.29.74