Band Electrodes in Sensing Applications: Response Characteristics and Band Fabrication Methods
نویسندگان
چکیده
منابع مشابه
Modified U-Slot Stacked Micro-Strip Patch Antenna for Ultra-Wideband Applications in S Band, C Band and X Band
The U-slot micro-strip patch antennas were originally developed for bandwidth broadening applications. This study presents a transmission line feed to modify the U-slot stacked rectangular micro-strip patch antenna for Ultra-Wide Band (UWB) communications. The modified antenna has a U-cut loaded with parallel slits and corner slots and is printed on a dielectric substrate of FR4 with relative p...
متن کاملAsymmetrical-fed RHCP Wide-Band Slot Element for X-Band applications
An outstanding square slot element, for x-band wireless applications with asymmetric coplanar waveguide fed (CPW) is proposed. Various shapes of metallic strips are utilized as grounded stubs for providing Right Hand Circular Polarization (RHCP) functionality and wide-band properties. By adjusting the proposed stubs and hook-shaped radiator, length and positions, wider impedance band width is o...
متن کاملDual-Band Evanescent-Mode Substrate Integrated Waveguide Band-pass Filter for WLAN Applications
A new multi-layer substrate integrated waveguide (SIW) structure is developed to design dual-band evanescent-mode band-pass filters (BPFs). Two independent series LC circuits are implemented by incorporating metallic irises in the different layers of the structure. The combination of the metallic irises with capacitive-plates is embedded inside the SIW to independently excite two evane...
متن کاملDesign, simulation and Fabrication of Circularly Polarized Fabry-Perot Antenna for Ku Band
This paper deals with the design and simulation of a RHCP Fabry-Perot antenna for 14.5 GHz. Based on transmission line model, partially Reflecting Surface (PRS) was designed so thatgain enhancement and circular polarization simultaneously obtained. PRS consist of a square loop and meander-line at the top and bottom respectively. In order to achieve the resonance condition in orthogonal componen...
متن کاملFabrication of photonic band-gap crystals
We describe the fabrication of three-dimensional photonic crystals using a reproducible and reliable procedure consisting of electron beam lithography followed by a sequence of dry etching steps. Careful fabrication has enabled us to define photonic crystals with 280 nm holes defined with 350 nm center to center spacings in GaAsP and GaAs epilayers. We construct these photonic crystals by trans...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ACS Sensors
سال: 2019
ISSN: 2379-3694,2379-3694
DOI: 10.1021/acssensors.9b01172