Balun LNA Thermal Noise Analysis and Balancing With Common-Source Degeneration Resistor
نویسندگان
چکیده
منابع مشابه
A Modified Noise Analysis of a Common Source ̶ Common Gate Low Noise Transconductance Amplifier for Sub-micron Technologies
This paper is based on analysis of a common source - common gate low noise transconductance amplifier (CS-CG LNTA). Conventional noise analyses equations are modified by considering to the low output impedance of the sub-micron transistors and also, parasitic gate-source capacitance. The calculated equations are more accurate than calculated equations in other works. Also, analyses show that th...
متن کاملComments on "on resistor-induced thermal noise in linear circuits"
In a recent paper [1], Giannetti considered the thermal noise generated by a resistor R on a generic output port in any linear network. He reasoned that, because the contribution of the thermal noise of the resistor to the output noise of the circuit vanishes for both R! 0 and R ! 1, there should be a resistor value whose contribution to the output noise is maximal. In order to find that value,...
متن کاملA Linearity-Improved Ultra-Wideband Balun-LNA for Cognitive Radio
An ultra-wideband low noise amplifier for cognitive radio applications covering 50 MHz to 10 GHz is designed in a 65-nm CMOS technology. A three-stage dc-coupled common source amplifier with RC degeneration at the last stage optimizes the gain, linearity and output gain-phase balancing. Throughout the covered band, the simulated voltage gain is >23.3 dB whereas the noise figure is <3.4 dB. The ...
متن کاملMesoscopic resistor as a self-calibrating quantum noise source
We present a method for the measurement of the noise of microwave amplifiers operating at the single photon level. It is based on the shot noise produced by a nanowire resistor in the hot electron regime. This noise source is simply controlled by a dc current and offers the advantage of being self-calibrating. After testing the noise source with a cryogenic high electron mobility transistor amp...
متن کاملThe BLIXER, a Wideband Balun-LNA-I/Q-Mixer Topology
This paper proposes to merge an I/Q current-commutating mixer with a noise-canceling balun-LNA. To realize a high bandwidth, the real part of the impedance of all RF nodes is kept low, and the voltage gain is not created at RF but in baseband where capacitive loading is no problem. Thus a high RF bandwidth is achieved without using inductors for bandwidth extension. By using an I/Q mixer with 2...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2020
ISSN: 2169-3536
DOI: 10.1109/access.2020.2984314