Automatic Identification of Power System Load Models Based on Field Measurements
نویسندگان
چکیده
منابع مشابه
application of upfc based on svpwm for power quality improvement
در سالهای اخیر،اختلالات کیفیت توان مهمترین موضوع می باشد که محققان زیادی را برای پیدا کردن راه حلی برای حل آن علاقه مند ساخته است.امروزه کیفیت توان در سیستم قدرت برای مراکز صنعتی،تجاری وکاربردهای بیمارستانی مسئله مهمی می باشد.مشکل ولتاژمثل شرایط افت ولتاژواضافه جریان ناشی از اتصال کوتاه مدار یا وقوع خطا در سیستم بیشتر مورد توجه می باشد. برای مطالعه افت ولتاژ واضافه جریان،محققان زیادی کار کرده ...
15 صفحه اولSystem for Dynamic Model Identification Based on Real Power System Measurements SYSTEM FOR DYNAMIC MODEL IDENTIFICATION BASED ON REAL POWER SYSTEM MEASUREMENTS
This paper presents a concept of a tool for verification of model parameters applicable to dynamic elements of the electric power system. The tool uses the PSLF design software, which is in general use by the transmission system operator. The innovation consists in using an additional application (in MS Windows environment) which controls the work of the design software. This results in a tande...
متن کاملFeeder Topology Identification using Consumer Load and Power Flow Measurements
Advanced control of distributed energy resources at the consumer level requires full situational awareness of the distribution system. This is typically performed by a topology identification and state estimation. In a distribution system, the topology is usually unknown since it depends on switch configurations on the network. In the case of residential feeders, switches may be passive compone...
متن کاملA Nonlinear Voltage Stability Index based on Vector Analysis Method and Measurements of Active and Reactive Powers of Power System
This paper proposes a new voltage stability assessment method based on vector analysis method. This index extraction process relies on measurements of active and reactive powers from connected buses to the generator buses. Therefore, a limit for beginning of voltage collapse is determined based on the maximum power transfer theory. On the other hand, when the system requires load shedding, a ne...
متن کاملWireless Load Self-Disconnection Module For Automatic Power Supply System
Nowadays, the use of Auxiliary power supply (APS) systems to energize low power rating appliances (e.g. televisions, water dispensers, etc.) and lighting (e.g. CFL lamps) has become pervasive in countries where long power rationing schemes are applied. Although the existing APS systems offer overload protection, it cannot be directly connected to the existing electric circuit unless heavy loads...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Power Systems
سال: 2018
ISSN: 0885-8950,1558-0679
DOI: 10.1109/tpwrs.2017.2763752