Automatic FEM Procedure Using a Geometry-Oriented h Version for 3D Solid Structures.
نویسندگان
چکیده
منابع مشابه
A FEM Multiscale Homogenization Procedure using Nanoindentation for High Performance Concrete
This paper aims to develop a numerical multiscale homogenization method for prediction of elasto-viscoplastic properties of a high performance concrete (HPC). The homogenization procedure is separated into two-levels according to the microstructure of the HPC: the mortar or matrix level and the concrete level. The elasto-viscoplastic behavior of individual microstructural phases of the matrix a...
متن کاملEfficient multigrid and data structures for edge-oriented FEM stabilization
We study edge-oriented FEM stabilizations w.r.t. linear multigrid solvers and data structures with the goal to examine the efficiency of such stabilizations due to the extending matrix stencil which is not supported by standard FEM data structures. A new edge-oriented data structure has been developed to support the additional coupling. So, the local element-wise and edge-wise matrices are easi...
متن کاملA fully automatic calibration procedure for freehand 3D ultrasound
This paper describes a novel method for calibration of freehand three-dimensional (3D) ultrasound. A position sensor is mounted on a conventional ultrasound probe, thus the set of B-scans can be localized in 3D, and can be compounded into a volume. The calibration process aims at determining the transformation (translations, rotations, scaling) between the coordinates system of images and the c...
متن کاملFEM Updating for Offshore Jacket Structures Using Measured Incomplete Modal Data
Marine industry requires continued development of new technologies in order to produce oil. An essential requirement in design is to be able to compare experimental data from prototype structures with predicted information from a corresponding analytical finite element model. In this study, structural model updating may be defined as the fit of an existing analytical model in the light of measu...
متن کاملA 3D elasto-plastic FEM program developed for reservoir Geomechanics simulations: Introduction and case studies
The development of yielded or failure zone due to an engineering construction is a subject of study in different disciplines. In Petroleum engineering, depletion from and injection of gas into a porous rock can cause development of a yield zone around the reservoir. Studying this phenomenon requires elasto-plastic analysis of geomaterial, in this case the porous rocks. In this study, which is a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 2000
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.66.239