منابع مشابه
Grain Size Effect on the Hot Deformation Processing Map of AISI 304 Austenitic Stainless Steel
In this study, the hot deformation processing map of AISI 304 austenitic stainless steel in two initial grain sizes of 15 and 40 μm was investigated. For this purpose, cylindrical samples were used in the hot compression test at the temperature range of 950-1100 °C and the strain rate of 0.005-0.5% s-1. At first, the relationship between the peak stress and Zener-Hollomon parameter w...
متن کاملFormation of annealing twins during recrystallization and grain growth in 304L austenitic stainless steel
Understanding of the mechanisms of annealing twin formation is fundamental for grain boundary engineering. In this work, the formation of annealing twins in a 304L austenitic stainless steel is examined in relation to the thermo-mechanical history. The behavior of annealing twins of various morphologies is analyzed using an in-situ annealing device and EBSD. The results confirm that there is a ...
متن کاملPossibility of Determining Steel Grain Size Using Ultrasonic Waves
The microstructure of steel is decisive for its chemical, physical and mechanical properties. Depending on the parameters characterising liquid metal as well as the parameters of the steel casting influencing the crystallisation process, the macrostructure of casts and ingots consist of three, two or only one crystallisation zone. In steel ingots, its most frequent by consist of three zones: ch...
متن کاملThe Effect of Hot Deformation Parameters on Grain Size Refinement in a Martensitic Stainless Steel
The grain size refinement of AISI 422 martensitic stainless steel in the temperature range of 950-1150 ºC was investigated by hot deformation tests. The deformed specimens were held at deformation temperature with delay times of 5 to 300s after achieving a strain of 0.3. The austenite grains exhibit a considerable growth at temperature higher than 1050˚C, while the grain coarsening is negligibl...
متن کاملExperimental Quantification of Phase Transformation in Austenitic Stainless Steel
This conference paper briefly discusses different techniques for measuring the evolution of the martensite content in cold-rolled stainless steel 301LN sheets under mechanical loading. Three methods are employed to measure the martensite content: (1) micrography, (2) bulk magnetic induction, and (3) local magnetic permeability measurements. The first two methods require the extraction of sample...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1939
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1915.25.6_475