Atom-Probe Tomographic Study of Precipitation in an Ultrafine-Grained Al-Zn-Mg-Cu Alloy (Al 7075)
نویسندگان
چکیده
منابع مشابه
Microstructural evolution , strengthening and thermal stability of an ultrafine - grained Al - Cu - Mg alloy
To gain insight into the origin of the ultra-high strength of ultrafine-grained (UFG) alloys, the solute clustering, precipitation phenomena, and microstructural evolutions were studied in an UFG Al-4.63Cu-1.51Mg (wt.%) alloy (AA2024) processed by high-pressure torsion (HPT). The thermal analysis was performed using differential scanning calorimetry. The microstructures, internal microstrains a...
متن کاملPrecipitation of a new platelet phase during the quenching of an Al-Zn-Mg-Cu alloy.
A previously undescribed high aspect ratio strengthening platelet phase, herein named the Y-phase, has been identified in a commercial Al-Zn-Mg-Cu alloy. Differential scanning calorimetry indicates that this phase only precipitates at temperature and cooling rate of about 150-250 °C and 0.05-300 K/s, respectively. This precipitate is shown to be responsible for a noticeable improvement in mecha...
متن کاملTHREE DIMENSIONAL ATOM PROBE ANALYSIS OF PRE-PRECIPITATE CLUSTERING IN AN Al-Cu-Mg-Ag ALLOY
Trace element additions in age hardening aluminum alloys often modify precipitation products and kinetics. In the case of Al-Cu alloy, combined addition of trace amount of Mg and Ag leads to precipitation of fine and uniform dispersions of plate-like Ω phase on the {111}Al planes in addition to the θ′ precipitates on the {001}Al planes [1,2]. The Ω phase shows high thermal stability and resista...
متن کاملPrecipitation Behavior and Quenching Sensitivity of a Spray Deposited Al-Zn-Mg-Cu-Zr Alloy
Precipitation behavior and the quenching sensitivity of a spray deposited Al-Zn-Mg-Cu-Zr alloy during isothermal heat treatment have been studied systematically. Results demonstrate that both the hardness and the ultimate tensile strength of the studied alloy decreased with the isothermal treatment time at certain temperatures. More notably, the hardness decreases rapidly after the isothermal h...
متن کاملDsc Study of Precipitation in an Al-mg-mn Alloy Microalloyed with Cu
Power compensation DSC has been employed to detect and analyse precipitation reactions in an Al1.3Mg-0.4Mn and an Al-1.3Mg-0.4Mn-0.07Cu alloy in which very small amounts of precipitate, less than 0.3 at%, are expected to form. Due to the very small heat effects, baseline instability and drift significantly interfere with the measurements. After repeated experiments and careful baseline correcti...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microscopy and Microanalysis
سال: 2013
ISSN: 1431-9276,1435-8115
DOI: 10.1017/s1431927613007113