ATOM-PROBE STUDY OF G.P. ZONES IN Ti-Cu ALLOYS

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

AN ATOM-PROBE STUDY OF Fe-Ti ALLOYS

The ToF atom-probe FIM was used to study surface segregation of Fe-Ti alloys. Ti segregates to the surface upon annealing at or above 650°C. The degree of segregation depends on the crystallographic orientation, 100% at the (110) and (111), 70% at the (100) and £50% at the (121) plane. It is found that the presence of H2(D2) during annealing enhances surface segregation of Ti and that oxygen de...

متن کامل

Corrosion Characteristics of a - Ti and Ti 2 Cu Composing Ti - Cu Alloys

A series ef binary Ti-Cu alloys containing 5-20 mass% Cu was prepared, and the corresien behavior of a-Ti and Ti2Cu composing the Ti-Cu alloys were examined based on the anodic polarization curves and released iens in O.9% NaCl and 1% lactic acid solutions. In both selutions, the Ti-Cu alloys showed the same anodic polarization curves as titanium in the conditien below 1.4 V. Hewever, precipita...

متن کامل

Thermodynamic and experimental study of Ti-Ag-Cu alloys

Phase equilibria in the ternary Ti-Ag-Cu system have been studied thermodynamically and experimentally at various temperatures. The thermodynamic analysis was performed by combining the most recent data on the binary Ag-Cu, Ti-Ag and Ti-Cu systems and experimental information obtained by the diffusion couple technique. The eutectic and three noneutectic binary Ag-Cu alloys were melted and annea...

متن کامل

Machinability of Experimental Ti-Cu Alloys

This study is an investigation of the machinability of experimental Ti-Cu alloys (2, 5, and 10mass% Cu) as new dental titanium alloy candidates for CAD/CAM use. The alloys were slotted with a vertical milling machine and carbide square end mills under two cutting conditions. Their machinability was evaluated through cutting force using a three-component force transducer fixed on the table of th...

متن کامل

ATOM PROBE CHARACTERIZATION OF PREPRECIPITATE CLUSTERS AND PRECIPITATES IN Al-Mg-Si(-Cu) ALLOYS

Pre-precipitation clustering and chemical nature of the metastable precipitates in aged Al-Mg-Si(-Cu) alloys have been investigated by atom probe field ion microscopy (APFIM) and transmission electron microscopy (TEM) for better understanding of the two-step aging behavior and the effect of excess Si. After a prolonged natural aging, co-clusters of Mg and Si atoms are observed in addition to se...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Le Journal de Physique Colloques

سال: 1986

ISSN: 0449-1947

DOI: 10.1051/jphyscol:1986748