Asymmetric Three-Point Bending of a Laminated Beam Containing a Delamination.
نویسندگان
چکیده
منابع مشابه
Using Finite Element Software to Simulation Fracture Behavior of Three-point Bending Beam with Initial Crack
using computation software to simulate fracture behaviors of structures can shorten the time to estimate safety of engineering structures and reduce a lot of cost of experiment. However three dimensional numerical simulation for fracture process is a challenging issue, because the convergence and accuracy are not easily obtained and high computational cost is generated. In this paper, three new...
متن کاملNumerical Determination of Delamination Onset in Laminated Symmetric DCB Specimen
In this study, a novel numerical method is proposed for determination of mode-I interlaminar fracture toughness, GIc, in multi-directional (MD) double cantilever beam (DCB) specimens using fracture properties of unidirectional DCB specimens. Two factors, β and Dc are defined to minimize the undesirable effects on strain energy release rate. β describes the difference between maximum and average...
متن کاملPhoto-induced bending in a light-activated polymer laminated composite.
Light activated polymers (LAPs) have attracted increasing attention since these materials change their shape and/or behavior in response to light exposure, which serves as an instant, remote and precisely controllable stimulus that enables non-contact control of the material shape and behavior through simple variation in light intensity, wavelength and spatially controlled exposure. These featu...
متن کاملPrediction of the Crack Kinking in a Sandwich Composite Beam Subjected to Three Point Bending Using the J Integral Concept
Composite materials utilizing the sandwich structure are a basic family of materials and possess a highly increasing use in modern industrial applications. Since the traditional approach to structural design and material selection tends to be replaced by the Fracture mechanics approach, it is worth understanding the way that the Fracture mechanics approach is applied. The traditional approach t...
متن کاملMixed-Mode Bending Method for Delamination Testing
A mixed—mode delamination test procedure was developed combining double cantilever beam (DCB) mode I loading and end-notch fixture (ENF) mode II loading on a split unidirectional laminate. By loading with a lever, a single applied load simultaneously produces mode I and mode II bending loads on the specimen. This mixed-mode bending (MMB) test was analyzed using both finite-element procedures an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1994
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.60.2266