Assembly of lightweight sandwich panels through joining by forming

STUDY OF JOINING MECHANISM (S) IN BRASS/STEEL/BRASS SANDWICH MATERIALS PREPARED BY SCRATCH BRUSHING METHOD

In this research, the mechanism of joining three sheets of metals, i.e. brass-steel-brass, by cold roll welding process has been studied. For this purpose, the two surfaces of steel sheets were roughened with stainless steel wire brush by different amounts, then the brass sheets were put on both sides of the steel sheets, before they were subjected to cold roll process. During rolling, peaks of...

Thermostructural Analysis of Honeycomb Sandwich Panels

Abstract The thermal analysis is performed on a heated Inconel 617 honeycomb-core sandwich panel. Sandwich panel is supported at its four edges with spar-like sub-structures that acted as heat sinks, which are generally not considered in the classical analysis. One side of the panel is subjected to a heat flux on the surface. Two types of surface heating were considered: (1) hexagonal honeycomb...

Design of metallic textile core sandwich panels

Metallic sandwich panels with textile cores have been analyzed subject to combined bending and shear and then designed for minimum weight. Basic results for the weight benefits relative to solid plates are presented, with emphasis on restricted optimizations that assure robustness (non-catastrophic failure) and acceptable thinness. Select numerical simulations are used to check the analytical r...

Passive Damping of Spacecraft Sandwich Panels

For reusable and expendable launch vehicles as well as for other spacecraft structural vibration loads are safety critical design drivers impacting mass and lifetime. Here, the improvement of reliability and safety, the reduction of mass, the extension of service life, as well as the reduction of cost for manufacturing are desired. Spacecraft structural design in general is a compromise between...

Structural behaviour of composite sandwich panels