Approaches to Poly(Tetrafluoroethylene) Adhesive Bonding
نویسندگان
چکیده
منابع مشابه
Adhesive bonding of composites
provision of large, stress-bearing area excellent fatigue strength good shock absorption reduced galvanic corrosion no need to have access to far-side of adherend to make joint bonding is possible on dissimilar materials provision of smooth contours and sections around joint areas sealing improved damping which increases structural stiffness reduction in distortion and metal...
متن کاملAdhesive Bonding of Wood Materials
Adhesion to Wood 9–1 Surface Properties of Wood Adherends 9–2 Extractives on Surfaces 9–3 Knifeand Abrasive-Planed Surfaces 9–3 Veneer Surfaces 9–4 Surfaces of Wood and Nonwood Composite Products 9–5 Physical Properties of Wood Adherends 9–6 Density and Porosity 9–6 Moisture Content and Dimensional Changes 9–7 Adhesives 9–9 Composition 9–9 Health and Safety 9–10 Strength and Durability 9–10 Adh...
متن کاملBonding stability of adhesive systems to eroded dentin.
This in vitro study evaluated the immediate and 6 months microshear bond strength (µSBS) of different adhesive systems to sound and eroded dentin. Sixty bovine incisors were embedded in acrylic resin and ground to obtain flat buccal dentin surfaces. Specimens were randomly allocated into two groups: sound dentin (immersion in artificial saliva) and eroded dentin (erosive challenge following a p...
متن کاملAdhesive Bonding to Dentin Improved by Polymerizable Cyclodextrin Derivatives
The objective of this work was to determine bonding characteristics of a hydrophilic monomer formulation containing polymerizable cyclodextrin derivatives. The hypothesis was that a formulation containing hydrophilic cross-linking diluent comonomers and cyclodextrins with functional groups attached by hydrolytically stable ether linkages could form strong adhesive bonds to dentin. The previousl...
متن کاملBonding effectiveness of adhesive luting agents to enamel and dentin.
OBJECTIVES The bonding effectiveness of five adhesive luting agents to enamel and dentin using different application procedures was determined using a micro-tensile bond strength protocol (microTBS). METHODS Enamel/dentin surfaces of human third molars were flattened using a high-speed diamond bur. Composite resin blocks (Paradigm, 3M ESPE) were luted using either Linkmax (LM; GC), Nexus 2 (N...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Adhesion
سال: 2011
ISSN: 0021-8464,1545-5823
DOI: 10.1080/00218464.2011.596778