Application of Aluminum and Aluminum Alloys in Engineering
نویسندگان
چکیده
منابع مشابه
Aluminum and Aluminum Alloys Casting Problems
Aluminum castings have played an integral role in the growth of the aluminum industry since its inception in the late 19th century. The first commercial aluminum products were castings, such as cooking utensils and decorative parts, which exploited the novelty and utility of the new metal. Those early applications rapidly expanded to address the requirements of a wide range of engineering speci...
متن کاملMicrowave Sintering of Aluminum Alloys
Until 2000 almost all research in the microwave sintering area was confined to non-metallic materials. However, after the first report by Penn State in 1999 on full sintering of steel powders in microwave, now in the last few years there has been increasing interest in applying microwave energy for processing of variety of metallic materials. The present study is an extension of this work and r...
متن کاملEffects on Structural Aluminum Alloys
HEDRICK, H. G. (General Dynamics/Fort Worth, Fort Worth, Tex.), C. E. MILLER, J. E. HALKIAS, AND J. F. HILDEBRAND. Selection of a microbiological corrosion system for studying effects on structural aluminum alloys. Appl. Microbiol. 12:197200. 1964.Two laboratory methods, a metal-strip test and a tank test, were evaluated as microbiological corrosion systems for producing corroded test specimens...
متن کاملTwinned dendrite growth in binary aluminum alloys
The formation of twinned dendrites (feathery grains) in binary Al–Zn, Al–Mg, Al–Cu and Al–Ni alloys has been studied in specimens directionally solidified under identical thermal conditions, i.e. G 100 K cm , v 1 mm s , and with slight natural convection in the melt. The influence of the solute element nature and content has been found to be of less importance than previously reported since fea...
متن کاملUltralow Temperature Anelasticity of Aluminum-Magnesium Alloys
Results of internal friction measurements on the commercial aluminum-magnesium alloys 5052,5086 and 5486 are reported here over the temperature range 50 mK to 300 K, and compared with published data on alloy 5056. Effects of heat treatment and explosive bonds on the internal friction are evaluated. The quality factor of proposed multi-layer aluminum-alloy spherical resonant-mass detectors of gr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Engineering Letters : Journal of Engineering and Applied Sciences
سال: 2018
ISSN: 2466-4677,2466-4847
DOI: 10.18485/aeletters.2018.3.2.2