Applicability of Potassium Titanate Fiber to Metal Matrix Composites
نویسندگان
چکیده
منابع مشابه
Fiber Fracture during the Consolidation of Metal Matrix Composites
-A detailed study of conditions leading to fiber fracture during the consolidation of Ti-14wt %A~21 wt%Nb/SiC (SCS-6) composite monotapes has been conducted. For this continuous fiber reinforced composite system, the incidence of fracture increases with consolidation rate at higher process temperatures. Increasing consolidation temperature at a fixed pressure reduces the number of breaks per un...
متن کاملDetermination of fiber length in axially symmetrical metal matrix composites
A procedure to calculate the spatial fiber length in discontinuously reinforced composites from data of conventional metallographical images is developed. The method is based on the following three assumptions: first, the measured length of a reinforcing fiber in a metallographical picture is a projection of the actual fiber length; second, the alignment of short fibers is axially symmetrical (...
متن کاملResin-based Copper-free Brake Pads: A Right Selection of Potassium Titanate and Ceramic Fiber
The present study aimed to assess the effect of replacing copper as a multi-functional ingredient in the brake pad material with potassium titanate platelet (PTP) and a particular type of ceramic fiber (CF) copper-free composite. Chase dynamometer tests were conducted to compare a brake padchr('39')s tribological behavior when PTP and CF are added to the composition with that of the copper-bear...
متن کاملBasics of Metal Matrix Composites
Metal composite materials have found application in many areas of daily life for quite some time. Often it is not realized that the application makes use of composite materials. These materials are produced in situ from the conventional production and processing of metals. Here, the Dalmatian sword with its meander structure, which results from welding two types of steel by repeated forging, ca...
متن کاملBi-continuous metal matrix composites
Bi-continuous alumina/aluminium composites were made by infiltrating an alumina preform which had the structure of a reticulated ceramic foam. The low density preforms were prepared from a polyurethane suspension of alumina powder which was pyrolysed and sintered after foaming. Higher density preforms consisted of ceramic foams with open cells. All these preforms were infiltrated with 6061 alum...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Institute of Metals
سال: 1983
ISSN: 0021-4434,2432-4701
DOI: 10.2320/matertrans1960.24.642