Appendix I. On Riveted Joints. Table Showing Rules of Practice used by various Manufacturers for Riveted Joints Entirely in Iron
نویسندگان
چکیده
منابع مشابه
Designing for Manufacturability in Riveted Joints
The study of human experts in the areas of design and manufacturing has lead to two hypotheses concerning the problem solving methods which these engineers utilize to attack difficult problems. The basis of both hypotheses is a modular approach to problem solving. One hypothesis addresses the nature of the modules utilized while the other hypothesis deals with the organization of the modules. A...
متن کاملOptimal Riveted Joints Design of Frame Strcture by IGA
Department of Systems and Information Engineering, Ashikaga Institute of Technology, Ashikaga 326-8558, Japan † Fuzzy Logic Systems Institute, Iizuka 820-0067, Japan Abstract In this paper, we formulate an optimal riveted joints design (ORD) problem of a through gusset plate on a frame structure for a constrained allowable stress as a rigid structural calculation problem and solve it directly b...
متن کاملResidual Strength Analyses of Riveted Lap-Splice Joints
Aging aircraft may develop multiple-site damage (MSD) that can reduce the structural integrity of fuselage structures. The existence of small cracks emanating from adjacent rivet holes in a fuselage lap-splice joint is of major concern. Small collinear cracks greatly reduce the residual strength of a panel with a lead crack. Recent studies predicting the residual strength of flat and curvilinea...
متن کاملEfect of Variations of Riveting Process on the Quality of Riveted Joints
This thesis presents a study of the effect of controllable riveting parameters, mainly squeeze force, rivet length, rivet diameter tolerance, hole countersunk depth and hole diameter tolerance, on the quality of formed rivet. The quality of a formed rivet is determined by the geometry of its head formation and the extent to which the hole is filled. The study determines maximum allowable tolera...
متن کاملFinite Element Modeling for Thermal Stresses Developed in Riveted and Rivet - Bonded Joints
A three-dimensional finite element modeling is developed using ABAQUS software. This includes riveted and rivet-bonded joints models. Both models undergo thermal heat caused by hot-driven rivet process and then are subjected to a constant velocity at one of its strip edges to simulate the shear tensile test up to the failure point. The developed FE models were based on elastic-plastic propertie...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the Institution of Mechanical Engineers
سال: 1881
ISSN: 0020-3483,2058-1203
DOI: 10.1243/pime_proc_1881_032_015_02