Anticorrosive performance of commercial nanoceramic coatings on AISI 1010 steel
نویسندگان
چکیده
منابع مشابه
Investigation of Effect of Phase Transformations on Mechanical Behavior of AISI 1010 Steel in Laser Forming
In laser forming, phase transformations in the heat affected zone take place under steep cooling rates and temperature gradients, and have a significant affect on the laser forming process and final mechanical properties of products. In this work, phase transformations during laser forming of AISI 1010 steel are experimentally and numerically investigated and the transient volume fraction of ea...
متن کاملAntibacterial and Tribological Performance of Carbonitride Coatings Doped with W, Ti, Zr, or Cr Deposited on AISI 316L Stainless Steel
Carbonitride (CNx) coatings have existed for several decades but are not well understood. Related studies have indicated that CNx coatings exhibit behaviors comparable to diamond-like carbon (DLC) coatings. Metal-doped CNx coatings are expected to show superior performance to single CNx coatings. In this study, a CNx coating and a group of CNx coatings with 6 at. % metal doping (W, Ti, Zr, or C...
متن کاملMorphology and Corrosion Performance of Chromate Conversion Coatings on Different Substrates
The aqueous corrosion resistances of galvalume (FeAl+Zn) and steel galvanized (Fe-Zn) alloys, passivated by immersion in chromating solution with different immersion times (0, 10, 30 y 60 s) are compared. The electrochemical behaviour of various chromated and non-chromated coatings was investigated in 3 wt-% NaCl solution using polarization techniques. For comparison, AISI 1010 carbon steel sub...
متن کاملOn machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملHot Forming of Aisi A2 Tool Steel
In order to optimize the hot forming process of tool steels, further improvement of flow stress prediction and additional knowledge on hot deformability, especially at lower and upper limits of the hot working range, are required. The hot working ranges for these steels are very narrow as a consequence of the role of alloying elements, which form carbides. Carbides improve tool steel’s hardenab...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research
سال: 2014
ISSN: 1516-1439
DOI: 10.1590/1516-1439.263514