ANOVA parameters influence in LCF experimental data and simulation results
نویسندگان
چکیده
منابع مشابه
simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Comparing the results of thermal simulation of rasoulian house in Yazd by design builder software, with experimental data
Environmental problems caused by fossil fuel consumption, on the one hand, and the upcoming prospect of ending these fuels on the other, attracted much attention towards sustainable architecture. Traditional buildings can be seen as a sample of sustainability; as they have used strategies to cope with the environment, which have been developed over the years, providing users’ comfort cond...
متن کاملNumerical simulation of in-cylinder tumble flow field measurements and comparison to experimental results
This paper presents a comparison between measured and predicted results of the in-cylinder tumble flow and the flow coefficient generated by a port-valve-liner assembly on a steady-flow test bench. In this study, computational fluid dynamics (CFD) methods were employed to gain further insight into characteristics of an engine. The purpose was to advance understanding of the stationary turbulenc...
متن کاملHe–Xe microdischarges: Comparison of simulation results with experimental data
A comparison of predictions of a one-dimensional simulation model with the results of a recent experimental study @Appl. Phys. Lett. 76, 544 ~2000!# of a dc He–Xe microdischarge is presented. The experimental results are remarkably reproduced by the model but only when unusually high values are used for the unknown rate coefficients of formation and recombination reactions of HeXe heteronuclear...
متن کاملModelling combined HCF-LCF fatigue crack growth under the influence of LCF overload
Fatigue crack growth (FCG) rates have previously been reported in forged Ti6Al-4V aero-engine disk material under the conjoint action of LCF and HCF cycles at room temperature. It is found that systematic increases in LCF overload, applied prior to the commencement of the HCF cycles, reduce the contribution of the HCF cycles to crack growth rates. The application of overload also enhances the s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: EPJ Web of Conferences
سال: 2010
ISSN: 2100-014X
DOI: 10.1051/epjconf/20100643003