Anomalous Mechanical Behavior in Stationary Small Crack Tips about EAC for Nickel-Base Alloy
نویسندگان
چکیده
منابع مشابه
High frequency fatigue crack propagation behavior of a nickel-base turbine disk alloy
Fatigue crack propagation tests were conducted on the powder metallurgy nickel-base superalloy KM4 at room temperature. Two different heat treatments were investigated, one which produced a relatively coarse grain size around 55 μm, and another which produced a very fine grain size around 6 μm. Tests were conducted at 50 Hz and 1000 Hz in an advanced servohydraulic testing machine at R-ratios b...
متن کاملReview on Thermo-Mechanical Fatigue Behavior of Nickel-Base Superalloys
Nickel-base superalloys have become the key materials of hot-end components in the aeroengines over the past several decades. Nickelbase superalloys are easy to produce thermo-mechanical fatigue (TMF) behavior when withstanding the combined effects of high temperature, creep, oxidation, mechanical stress and thermal stress. The occurrence of TMF seriously affects the normal service for hot-end ...
متن کاملCrack Behavior of the Aluminum Alloy 2024 Under Fretting Conditions
The initial stage of fretting fatigue crack growth is significantly influenced by tangential force induced by fretting action along the contact surface where a mixed-mode crack growth is involved. Fretting crack behavior of aluminum alloy 2024 was studied, taking into account the problem of contact asperities. Finite element was used for the determination of the stress field near the contact su...
متن کاملMechanical behavior of Nickel base foams for Diesel Particle Filter applications
An original processing route by powder metallurgy was developped to alloy pure Ni foams so, that the foam becomes refractory for high temperature applications. The modelling of such a foam at high temperature starts from the behavior of the basic constitutive material, then we use micromechanical models to predict the mechanical properties under tension and in compression creep. A 3D finite ele...
متن کامل[Mechanical studies on casting titanium alloy denture base].
The mechanical properties of the Akers type clasp, bar and frame made by the newly developed Ti-20Cr-0.2Si alloy were studied in order to obtain the indices for designing the cast partial denture base. In the case of the clasp, the bending strength of the Ti-20Cr-0.2Si alloy and pure Ti was lower than that of the Co-Cr alloy. The Ti-20Cr-0.2Si alloy and pure Ti may have the same retentive force...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Rare Metal Materials and Engineering
سال: 2016
ISSN: 1875-5372
DOI: 10.1016/s1875-5372(16)30062-5