Anodic etching of aluminum in HCl used by triangular pulse current.
نویسندگان
چکیده
منابع مشابه
Nanoporous anodized aluminum thickness optimization through pulse current mode
The purpose of this study was to optimize the thickness of anodizing Aluminum coatings processed under pulse current mode through the Design of Experiments (DOE) method. Thickness measurement, polarization and electrochemical impedance spectroscopy were employed to take Thickness and corrosion behaviors of the anodized coatings into consideration. Also, Field-emission scanning electron microsco...
متن کاملOptimization of the FeCo nanowire fabrication embedded in anodic aluminum oxide template by response surface methodology
Anodic aluminum oxide (AAO) fabricated by two step anodization technique, is used as a template to synthesize FeCo nanowire arrays by AC electrodeposition technique. Response surface methodology (RSM) is applied to design the experiments, fit an empirical model and optimize the conditions to achieve the best magnetic properties. The magnetic properties, pore dimensions, composition and structur...
متن کاملAnodic aluminum oxide microchannel plates
A new material for microchannel plates (MCP) is proposed — anodic aluminum oxide. Microchannel plates made of this material may be much cheaper than with conventional lead glass MCP. Also a significantly smaller channel diameter (up to 70 nm) is easily achievable, which means better spatial resolution and the possibility to operate in strong magnetic fields. Methods and means are developed for ...
متن کاملCorrosion Resistance Improvement of Aluminum by Hydrophobic Anodic Oxide Film
Diminishing surface wettability is an effective method to improve corrosion resistance of aluminum. Various techniques for preparing hydrophobic surface have been reported, most of which use organic coating as the final step. The key point to diminish surface wettability is to form a fine regular surface structure, and the porous type anodic oxide film (PAOF) has nano-pore structure, therefore ...
متن کاملIn situ determination of the pore opening point during wet-chemical etching of the barrier layer of porous anodic aluminum oxide: nonuniform impurity distribution in anodic oxide.
Wet-chemical etching of the barrier oxide layer of anodic aluminum oxide (AAO) was systematically investigated by using scanning electron microscopy (SEM), secondary ion mass spectrometry (SIMS), and a newly devised experimental setup that allows accurate in situ determination of the pore opening point during chemical etching of the barrier oxide layer. We found that opening of the barrier oxid...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Surface Finishing Society of Japan
سال: 1989
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.40.158