Anneal-Hardening of α-Brass Polycrystals Deformed in Tension or Rolling
نویسندگان
چکیده
منابع مشابه
Sympathy or Brass Tacks
as A regional social worker for the Spastics Society I am increasingly aware of the diversity of my clients' needs, their dependence for facilities on specific geographical areas and the way local authorities interpret the statutory provisions. The knowledge that spasticity is irreversible makes an immediate impact. However I try I know I cannot change the status quo and this is the premise on ...
متن کاملEffect of the asymmetrical rolling process on the micro hardness and microstructure of brass wire
Current experimental investigation deals with the effects of asymmetrical rolling parameters on the inhomogeneity, microstructure, mechanical, and geometrical properties of rolled brass wire. Toward this end, a roll machine with three different roll radii ratios was set up. The asymmetrical conditions are arranged using three different sets of rolls with different diameters that result into dif...
متن کاملThe Anneal Hardening and Deformation Softening Behaviors of Nanocrystalline Cu-Zn Alloys
The changes in the mechanical properties and microstructure of nanocrystalline Cu-Zn alloys deformed by cryorolling during low temperature annealing and the post-process deformation were studied. The deformed Cu-Zn alloys exhibited uncommon anneal hardening and deformation softening behaviors. The degree of anneal hardening and deformation softening increased with the addition of the solute ato...
متن کاملSTUDY OF JOINING MECHANISM (S) IN BRASS/STEEL/BRASS SANDWICH MATERIALS PREPARED BY SCRATCH BRUSHING METHOD
In this research, the mechanism of joining three sheets of metals, i.e. brass-steel-brass, by cold roll welding process has been studied. For this purpose, the two surfaces of steel sheets were roughened with stainless steel wire brush by different amounts, then the brass sheets were put on both sides of the steel sheets, before they were subjected to cold roll process. During rolling, peaks of...
متن کاملGenetic Fuzzy Tension Controller for Tandem Rolling
A fuzzy logic control (FLC) is designed to maintain constant tension for tandem rolling mills. Genetic algorithm (GA) is used as self-organization technique for FLC to locate the optimal parameters. Simulation results verify the superior performance of genetic fuzzy controller. Keywords-tension control, fuzzy logic, genetic fuzzy system, rolling mill.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1980
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.44.7_790